1 - 10 of 27
five point penetration test block
Selling leads
|
... test block has a rough surface in the sandblasting area, which is used to verify the cleaning performance of the penetrant and the accuracy of the ...
2024-12-16 14:30:17
|
|
... accuracy of the penetrant. At the same time, the test block has a rough surface in the sandblasting area, which is used to verify the cleaning ...
2024-12-16 14:30:18
|
|
...DPI system performance. Reference block type 2 is made from stainless steel plated with a layer of nickel then a hard Chromium alloy. Five star...
2025-07-10 07:30:29
|
|
... plated on one side, and three radial crack areas were formed by applying different loads on the back of the block by Brinell hardness method. The ...
2024-12-09 22:07:10
|
|
...Test Block Type II ISO 3452-3: 2013 describes two types of reference blocks - Type 2 reference blocks are for routine assessment of DPI system ...
2024-12-09 23:16:19
|
|
penetrant calibration block test block PT test specimen developer,remover Model:YM-B All linear dimensions to the requirements of AS2083/2005, BS2704...
2024-12-09 18:45:33
|
|
...Block Penetrant Testing Specimen YM-A Aluminum Alloy Material Through the physical and chemical test type A block material for LY12 aluminum alloy ...
2024-12-09 23:42:24
|
|
Calibration Block Penetrant Testing Specimen YM-B(B3) Depth 100μm Width Target Value 0.5μm Model:YM-B(B3) All linear dimensions to the requirements of ...
2024-12-09 23:42:24
|
|
...sensitivity comparison of new and old penetrants. The test block has symmetrical defects on both sides A and B, and can be compared with different ...
2024-12-16 14:30:18
|
|
... of GB/T6394/2002. where practicable tolerances to (+/-0.1mm) unless otherwise stated. Material: Test Report according to ISO 10474-3.1.B,JIS G ...
2024-12-09 22:08:10
|