21 - 30 of 214
go and not go gauge
Selling leads
|
... dimensions of the screw thread and dimension T1 minimum of E40 caps on finished lamps. Testing: when the cap on a finished lamp has been screwed ...
2025-06-20 20:17:37
|
|
...the lampholder shall be assumed to be correct if the gauge does not enter by its own weight so far that the thread protrudes beyond surgace T. ...
2025-06-20 20:17:41
|
|
...gauge | Gauge for finished lamps fitted with E14 caps for testing contact making | 7006-54-2 Purpose: to check lamp dimensions for contact making ...
2025-06-20 20:17:41
|
|
...: when the cap on a finished lamp has been pushed into the gauge as far as it will go, the plunger surgace W shall be co-planar with or project ...
2025-06-20 20:17:41
|
|
...gauge | Gauge for finished lamps fitted with E14 caps for testing protection against accidental contact E14-7006-55-2 Purpose: to check protection ...
2025-06-20 20:17:42
|
|
...contact(s) of lampholder shall be electrically connected with the gauge as shown in the circuit. with the central rod in the upper position, the ...
2025-06-20 20:17:43
|
|
...gauge | Gauge for testing protection against bulb-neck damage and for testing contact-making in lampholders E40-7006-23-3 Purpose: to check the ...
2025-06-20 20:17:43
|
|
E26d Lamp Cap Gauge | Gauge With Reference Diameter Of 23mm For Caps E26d | 7006-29B-2 PURPOSE To check dimensions Smin., Smax., S1min. and S1max. of ...
2025-06-20 20:17:44
|
|
...lamps. TESTING: When the lamp has been pushed into the gauge as far as it will go with the side solder of the cap located in the recess provided, ...
2025-06-20 20:17:44
|
|
... (1) This section is used only to provide additional mass so as to bring the total mass of the gauge to the required value. PURPOSE: To check ...
2025-06-20 20:17:47
|