61 - 70 of 90
e40 lamp cap gauge
Selling leads
|
...lamps. TESTING: When the lamp has been pushed into the gauge as far as it will go with the side solder of the cap located in the recess provided, ...
2025-06-20 20:17:44
|
|
...lamp cap gauge | "Go" and "Not Go" gauge for unmounted bi-pin cap(not for use on finished lamps) G5-7006-46-3 Purpose: to check ...
2025-06-20 20:17:43
|
|
...h lamps having adverse dimesions. b) protection against accidental contact with live parts, viz, the cap shell, during insertion of a lamp. Testing...
2025-06-20 20:17:40
|
|
...: "go" Gauges For Screw Threads of Lampholders E14, 7006-25-7 "not go" gauges for screw threads of lampholders E14, 7006-26-4 Plug Gauge For E14 ...
2025-06-20 20:17:41
|
|
... b) dimension X according to sheet 7005-20 c) the machnical compatibility of the lamp holder with respect to lamps have adverse dimensions Testing: ...
2025-06-20 20:17:42
|
|
...Gauge for Testing Contact-Making and Protection Against Accidental Contact During Insertion of Lamps in Lampholders The drawing is intended only to ...
2025-07-01 21:23:51
|
|
.... TESTING: (a) When the gauge is screwed fully home with a torque of: - 1,0 Nm* for ceramic holders, - 0,4 Nm* for alltoher holders, there shall be ...
2025-07-01 21:23:50
|
|
Zhaga book 18 -Annex B Mechanical drawing of the Mechanical-stop-gauge 5.1.1 Mechanical-stop-gauge The Mechanical-stop-gauge is defined in Annex B. ...
2025-06-20 20:17:45
|
|
Not go gauges for screw threads of lampholders E14 | 7006-26-4 Purpose: to check the maximum minor diameter of the screw thread, dimesion D1, of ...
2025-06-20 20:17:41
|
|
... on the lampholders, in order to prevent the damage of the lampholders from being damaged by excessive bending moment. Test Principle: Using a push...
2025-06-20 20:17:33
|