291 - 300 of 538
torque testing equipment
Selling leads
|
...IEC60695-11-5 . The equipment specifies a needle-flame test to simulate the effect of a small flame which may result fro...
2024-12-09 18:28:01
|
|
... a standard required conditions for temperature rising test of electric appliance.The Black Test Corner is used for the measurement of the ...
2024-12-09 19:58:25
|
|
...nominal wire diameter of which is 50μm and the nominal width of a gap between wires 75 μm. IP5X test: the protection is satisfactory if the power ...
2024-12-09 20:02:00
|
|
...Testing and Leakage Detection 1. Introduction High pressure leak testing machine can meet the requirement of IEC60529 for IPX8 testing and IEC60598...
2024-12-09 21:05:43
|
|
...-2-13, GB/T 5169.13, IEC62368-1 Section 6.3.1, IEC60598-1 Section 13.3.2, IEC60335-1 Section 30.1. It is widely used in material testing on lamps, ...
2025-04-25 12:32:49
|
|
...Testing Needle Flame Test Apparatus 1. Introduction The needle flame test apparatus is designed according to the requirements of IEC 60695-11-5, GB...
2025-04-25 12:32:48
|
|
IEC61010-1 Flammability Testing Tracking Index Test Device 1. Introduction The tracking index test device is designed according to the standards IEC ...
2025-04-27 00:06:27
|
|
...Mechanical Impact Test Apparatus IEC62262 1. Introduction The pendulum hammer mechanical impact test apparatus can meet the test requirements of ...
2026-06-20 00:30:41
|
|
...-2-75 test Ehc and IEC62262. The equipment consists of striking elements, swing pipes and test rig. The striking elements for IK07 (2J) to IK11 ...
2026-01-05 00:24:05
|
|
... to test the load-bearing capacity of equipment brackets that are intended to be installed on walls or ceilings. 2. Standard IEC61010-1 Medical ...
2025-04-26 07:40:05
|