141 - 150 of 239
enclosure test finger probe
Selling leads
|
...ween the access probe and hazardous parts. For the test of first characteristic numeral 1 , the access probe 50 mm diameter shall not completely ...
2024-12-09 13:06:35
|
|
...Test Equipment IEC 60132 60335 Standard Test Probe Pin Thorn Kit Product information: The IEC 60132/60335 standard Test Probe Pin Thorn Kit are the ...
2024-12-09 10:54:33
|
|
...,IEC60335 and IEC60598. As required in the standards, it is used to test the mechanical integrity of product enclosures. After applying the impact ...
2024-12-09 10:47:48
|
|
.... As required in the standards, it is used to test the mechanical integrity of product enclosures. After applying the impact with the hammer, the ...
2024-12-09 10:47:48
|
|
10N / 20N / 30N Finger Nail Test Equipment IEC 60335 Figure 7 Product information: The test finger nail complies with the IEC 60335 figure 7 standard ...
2024-12-09 10:47:48
|
|
...test conforms to the standard requirements of IEC60068-2-63,IEC60068-2-75,IEC60335 and IEC60598. As required in the standards, it is used to test ...
2024-12-09 10:47:48
|
|
...Test Equipment Test Sphere Probe With Force Of 0-50N This probe is intended to verify protection of persons against access to hazardous parts for ...
2024-12-09 13:06:50
|
|
... is given in table 1 . Other IEC publications should refer to a test probe of this standard by means of its code (column 2) and short description ...
2024-12-09 13:28:15
|
|
IEC60529 IP Testing Equipment Test Probe D for IP4X 1mm Probe Product Introduction for IP Testing Equipment: The 1.0mm test rod conforms to IEC61032 ...
2024-12-09 22:22:38
|
|
...Test Equipment Test Probe B With 12mm Diameter IEC60745-2-5 clause 19.101.2.4 For checking the accessibility of the cutting edge zone at the front ...
2024-12-09 17:12:04
|