481 - 490 of 690
non combustibility test equipment
Selling leads
|
... material(Ni80/Cr20) and heating wire in required shape(Φ4mm-chromel-filament)heated up to test temperature( 550 ℃ ～ 960 ℃) for 1min and then broil ...
2025-06-20 20:19:19
|
|
... limiters. This IC current limiter tester is based on the latest industry standards (such as Appendix Table G.11) to achieve fully automated ...
2025-07-30 00:05:06
|
|
...h software, which can display pressure curve in real time, output test report and save test data. Meet the test standard yy0469-2011 surgical mask ...
2025-07-01 21:23:41
|
|
... or specified, a 1 m length of 2,5 mm 2 or 12 AWG shall be used. For DC sources, the cable shall be sized for the maximum rated current of the ...
2025-07-30 00:05:06
|
|
... test data. GB 19083-2003-2011 GB/T 4745 requirements. Characteristics of the equipment 1. Configure funnel for detection. 2. The height can be ...
2025-07-01 21:23:41
|
|
...) can be exerted on ME equipment parts intended to support or suspend a PATIENT or OPERATOR in NORMAL USE, the ME EQUIPMENT shall maintain BASIC ...
2025-06-20 20:16:51
|
|
Needle Flame Tester Brief Introduction Needle Flame Tester is a simulation experiment project using non-flame ignition source in accordance to ...
2025-07-30 00:05:06
|
|
... standard IEC 62262:2002 - relates to IK ratings. This is an international numeric classification for the degrees of protection provided by ...
2025-06-20 20:19:48
|
|
...sharp edge of the electrical products, such as computers, daily household appliances and electronic equipments, is hazardous to user in touchable ...
2025-06-20 20:21:18
|
|
... of moisture loss- HME 6.2 Measurement of moisture loss 6.2.1 Principle The performance of an HME shall be measured by recording the mass of water ...
2025-07-30 00:05:06
|