Precison Single Point Load Cell 10kg Single Point Load Sensor 20kg
High accuracy Single Point Load Cell FH03 utilizes strain gauge technology which delivers maximum 0.015% non-linearity of the rated capacity.Load sensor FH03 offers 0-3kg / 0-6kg / 0-10kg / 0-20kg / 0-40kg
five rated measuring ranges to choose from.To achieve stable
measuring results,weighing loadcell FH03 is temperature
compensated.Weight Sensor FH03 is corner trimmed for platform sizes up to 250x350mm,
which makes it suitable for weight measurement where load center is
not constant.You may find Load Cell Sensor FH03 applicable for
bench scales,electronic scales,counting scales and other
industrial weighing applications.
Specifications
| Capacity | 3kg / 30N / 6.6 lb 6kg / 60N / 13.2 lb 10kg / 100N / 22 lb 20kg / 200N / 44 lb 40kg / 400N / 88 lb |
| Rated output | 2.0 mV/V |
| Excitation | 3-15V |
| Zero balance | ±0.1mV/V |
| Nonlinearity | ±0.015% R.O. |
| Hysteresis | ±0.015% R.O. |
| Nonrepeatability | ±0.01% R.O. |
| Creep(30min) | ±0.02% R.O. |
| Safe overload | 150% F.S. |
| Ultimate overload | 200% F.S. |
| Compensated temperature | -10...+40oC |
| Operating temperature | -20...+60oC |
| Temperature shift zero | ±0.02% R.O./10oC |
| Temperature shift span | ±0.02% R.O./10oC |
| Input resistance | 410±10 ohms |
| Output resistance | 350±5 ohms |
| Insulation resistance | >5000M ohms |
| Ingress protection | IP65 |
| Material of element | Aluminum alloy |
| Cable | Ø4*400mm 4-core |
| Wiring code | Red--Excitation+ Black--Excitation- Green--Signal+ White--Signal- |
A Load Sensor is a transducer that converts mechanical load into electrical
signal which is proportional to the load being applied.The measured
load or force causes deformation of the measuring element(elastic
body),the bonded strain gauge deforms accordingly which will cause
the resistance change of the wheatstone bridge,under constant power
supply, the output signal between Sig+ and Sig- will change
proportionally, thus the load/force can be measured by measuring
the output signal from the load cell which is normally within
0-30mV. Overloading is the most common cause of loadcell failure, a
loadcell is just like a spring in certain aspects, which will be
damaged if overstretched or overloaded. A machanical stop(refer to
below picture) can be used to protect the sensor from excessive
deformation. The deformation distance can be determined by loading
the sensor with rated capacity, then adjust the meachnical stop to
reach the bottom of the transducer. In most cases, the load
transducer will be used to measure load at 40-80% of the full
scale, thus the deformation distance can be adjusted using
reference load which is a bit higher than the maximum target load
to be measured instead of the rated capacity.
Precison Single Point Load Cell 10kg Single Point Load Sensor 20kg
Click here to download datasheet
