131 - 140 of 178
pin bending test apparatus
Selling leads
|
Test Probe 13 Conincal Pin Conforms to IEC61032 Accessability Test Finger Probe Introduction: It is designed according to IEC61032 figure 9. The pin ...
2024-12-09 18:22:24
|
|
Apparatus for Mechanical Strength Test on Resilient Covers BS1363-1 Figure 2 for Plug and Socket Tester 1. Introduction Apparatus for mechanical ...
2025-06-29 00:36:29
|
|
... Long Taper Test Pin / Cylindrical Pin Φ4-length 50 / Test Probe 12 Made by Metal and Nylon 1. Introduction: Test probe 12 (cylindrical long taper ...
2024-12-09 18:35:34
|
|
...Test Pin Made of Hardened Steel 1. Introduction Hardened steel Pin is designed according to IEC60950 clause 2.10.8.4 and IEC60335-1 clause 21.2. It ...
2024-12-09 18:47:52
|
|
... with a apex angle of 40°. The tip should be rounded with radius of 0.25 mm ± 0.02 mm. The hardened steel pin should work with abration reistance ...
2024-12-09 18:54:54
|
|
...Test Finger Probe and Short Test Pin Probe The test finger probe and short test pin probe are designed according to IEC61032 standard. The test ...
2024-12-09 19:16:17
|
|
...-1 clause 21.2, a hardened steel pin is used as a electrode during the dielectric strength test. After the scracth test, the device should work ...
2024-12-09 21:57:15
|
|
... of the enclosure under test with oscillating tubes (R200-R1600), or the support of the enclosure may be moved up or down. The test is mainly apply ...
2025-07-29 00:07:19
|
|
...Apparatus 1. Introduction The lamphoders e14, E27 and E40 pressure apparatus are designed accoding to IEC(BS EN)60238 clause 15.7 and figure 9, it ...
2025-07-29 00:07:19
|
|
... equipment during the tests from heating and abnormal operation. One is designed and made with the intention of determining the fulfillment of ...
2024-12-09 18:28:53
|