1 - 10 of 70
go no go gauge
Selling leads
|
... for contact making in IEC holders. Testing: the shape of the lamp with regard to the fit in the lampholder is assumed to be correct, if the lamp ...
2025-07-09 00:09:13
|
|
... certification authorized by CNAS on request. ● 7006-24B-1: "Go" gauge for caps on finished lamps ● 7006-24C-1: "Not Go" gauge for caps on finished ...
2025-07-09 00:09:13
|
|
... caps on finished lamps 7006-27C-1 “Go” gauge for dimension “S1” of E27 caps on finished lamps 7006-28A-1 “Not Go” gauge for E27 caps on finished ...
2025-07-09 00:09:13
|
|
... be called to go / no go gauge. The structure and sharp (like thread waveform) of gauges for lamp cap and lampholder are calculated and optimized ...
2025-07-09 00:09:13
|
|
... of the lampholder screw thread and dimension X shown on sheet 7005-20 Testing: it shall be possible to screw the gauge into the lampholder without ...
2025-07-09 00:09:13
|
|
IEC60061-3 Lamp Holder Gauge for E27 Go Gauge No Go Gauge and Protection Gauge 1. "Go" Gauge for Lampholders E27 (7006-25A-2) Purpose: To check: a. ...
2025-07-09 00:09:13
|
|
...dimension T1 minimum of caps on finished lamps shown on sheet 7004-21. Testing: When the cap on a finished lamp has been screwed into the gauge as ...
2025-07-09 00:09:13
|
|
...Gauge and Protection Gauge for Lampcap E40 7006 - 52 7006 - 53 Gauge for finished lamps fitted with E40 caps for testing contact making (7006-52-1) ...
2025-07-09 00:09:13
|
|
...Gauge Go Gauge 7006 - 45 and No Go Gauge 7006 - 44 “Go” Gauge for Bi-pin Cap G13 on Finished Lamps (7006-45-4) Purpose: to check dimensions E max,, ...
2025-07-09 00:09:13
|
|
...Gauges for Lampholder Lampcap and Bases with CNAS Certificates 1. Introduction Lamp cap and Lampholder Gauges are designed according to IEC60061-3, ...
2025-07-09 00:09:13
|