Lampholder Go No Go Thread Gauge Candle Sharped Shaft For Checking Dimensions

Go Not Go Gauges for Lampholder E14 Plug Gauge and Contact Gauge 7006-25 7006-26

Go gauges for screw threads of E14 lampholders (figure number: 7006-25-7)

Purpose: to check the minimum dimensions of the lampholder screw thread and dimension X shown on sheet 7005-20

Testing: it shall be possible to screw the gauge into the lampholder without using undue force.

Not go gauges for screw threads of E14 lamp holders (figure number: 7006-26-4)

Purpose: to check the maximum minor diameter of the screw thread, dimension D2 of lampholder E14.

Testing: the screw thread of the lampholder shall be assumed to be correct if the gauge does not enter by its own weight so far that the thread protrudes beyond surface T.

Plug gauge for E14 lampholder for testing contact making ( 7006-30-2)

Note: the application of this gauge is restricted to lampholders for lighting fittings equipped with the lamps (candle lamps, round bulb lamps, domestic tubular lamps, pygmy lamps) when these are fitted with E14 caps, in accordance with sheet 7004-23

Plug gauge for lampholder E14 with candle sharped shaft for candle lamps for testing contact making (7006-30A-1)

This gauge is to be used for testing contact making in lampholders with candle sharped shafts designed especially to make candle lamps only.

Gauge for testing contact-making and protection against accidental contact during insertion of lamps E14 lampholder (figure number: 7006-31-4)

Note: the application of this gauge is restricted to lampholders for lighting fitting equipped with lamps (candle lamps, round bulb lamps, tubular lamps, pygmy lamps) when these are fitted with E14 caps, in accordance with sheet 7004-23

Picture:

List of Gauge for Lampholder:

Note: We accept customized gauges, please just send us the figure number on the inquiry, all the gagues can pass the third-lab calibration and get the ceritificates autorized by CNAS (IS017025).