Stainless Steel Lamp Cap Gauge , Go And Not Go Gauge CANS Approved

IEC60061 - 3 G5 lamp Cap Gauge Go Not Go Gauge 7006 - 46A and 7006 -46 with CANS Certificate

Go Gauge for Bi-pin Cap on Finished Lamps G5 (7006-46A-3)

The G5 go gauge is designed according to IEC60061-3 standard figure 7006-46A-3, it's made of stainless steel and each one equipped with a third-party CNAS calibration certificate which accepted by ISO17025 Lab.

Purpose: to check dimensiions E max., F min., F max. And the combined pin diameter and displacement of pins (including bossed) of bi-pin caps G5 on finished lamps.

Testing: The pins of the caps on finished lamps shall enter the gauge at surface O and, when fully inserted. The surfaces of cap and gauge shall contact.

In this position the ends of the pins shall be co-planar with or project beyond surface X, but shall not project beyond surface Y.

Each individual pin shall enter hole e1 at surface O until the face of the cap and the surface of the gauge contact.

“Go” and “Not Go Gauge” for unmounted Bi-pin Gauge G5 (7006-46-3)

Purpose: To check dimensions E min., E max., F min., G max., H max. And the combined pin diameter and displacement of pins (including bosses) of unmounted bi-pin caps G5.

Testing: The pins of the cap shall enter the gauge at surface O and then fully inserted, the surfaces of cap and gauge shall contact. In this position the ends of the pins shall be co-planar with or project beyond surface X. Each individual pin shall enter the hole e2 until the boss of the pin and the surface of the gauge contact, but they shall not enter hole e1. The boss of the individual pin shall enter hole b at surface O until the surfaces of the cap and the gauge contact.

Picture:

7006-46A-3

7006-46-3

List: