Drilling Mud High-Pressure Shear Pump Units For Barite And Bentonite Mixing

The Shear Pump is used to shear, refine, mix polymer, bentonite, etc drilling mud material. It can remove "fish-eye" to help to drill fluid achieve high properties for oil drilling. Sunbo Shearing pump can save over 30% bentonite. As one very important equipment within the drilling fluid circulating system, shearing pumps perform the dual function of cutting and pumping, making the drilling fluid ideally suited for every drilling requirement of reducing solids size, and protect its downstream equipment.

Drilling mud shear pump is specially used to shear polymer and clay in drilling fluid. The polymer or clay in drilling fluid should be sufficiently cut before entering the drilling fluid system, which is helpful for the polymer to play an effective function and improve drilling performance. If the polymer is not fully cut, it may block the shale shaker screen in the first cycle and results in a large amount of loss, increasing the cost of drilling and making large size solid particles in the drilling fluid become hard and difficult to remove.

The shear pump is specially designed with the impeller holding jags to process the drilling mud mixed with clay and polymer. 

Details of drilling mud shear pump

The Shearing pump consists of the impeller, casing, packing, shaft, belt, pulley, motor, base, and so on. The difference with other pump impellers is a more complicated structure. There are axial whirl flow, fluids reserve compartment, pump wheel, pressure cabin, shearing plate.

The axial flow whirl provides a certain quantity of fluids to the pump wheel and reserve cabin, 50% of this part fluids will flow into the reserved cabin, and the other half part flows into the casing. A pressure cabin is a special design to make sure fluids cabin holding drilling mud. The fluids flow is parallel to the shearing plate and introduces high flow velocity

Why select APJQB series shearing pumps?

There are many features of the shearing pump as follows. High efficiency, high flow rate, high lead, mechanical sealed. It can help get higher performance and a better shearing effect. Faster hydration and dilution processes, meet the requirements of many different job sites. Saving the cost and time for the user. For bentonite use, it can save cost up to 30%

Operating the AIPU shear pump, the shearing and hydration system will be a mature and complete system.

Shear pump for drilling fluids solids control

APJQB series Shear Pump is special-purpose equipment of the solids control system which can meet all customers’ requirements of preparing drilling fluid for the well drilling. This shear pump manufactured by Aipu company is used to treat the high property mud, make the mud to obtain good rheological properties and cut the drilling cost as much as possible. This ideal solids control equipment designed by GN’s engineers has high performance and gained customers’ high evaluation.

Moreover, the shear pump can be customized according to practical working conditions and the user's special requirements. For example, it can be fit on a big rectangular base or a smaller area base. And the vertical angle can be adjusted accordingly.

If you have any demand for a drilling fluids shearing pump, Or you are interested in any other mud equipment. Please feel free to contact AIPU Solids. Trust you will get the real cost-effective solution at the best rate.