151 - 160 of 801
standard test finger probe
Selling leads
|
IEC60529 IP Testing Equipment Test Probe D for IP4X 1mm Probe Product Introduction for IP Testing Equipment: The 1.0mm test rod conforms to IEC61032 ...
2024-12-09 22:22:38
|
IEC 60529 Diameter 12.5mm Rigid Sphere Probe With Force Of 10N-50N IP First Characteristic Numeral 2
|
...Standard:IEC61032 figure 6 probe 2,IEC60529 of IP2. Application:It is intended to verify the degree of protection of enclosures against ingress of ...
2024-12-09 13:51:51
|
|
...,IEC60335 and IEC60598. As required in the standards, it is used to test the mechanical integrity of product enclosures. After applying the impact ...
2024-12-09 10:47:48
|
|
...Test Equipment Test Probe B With 12mm Diameter IEC60745-2-5 clause 19.101.2.4 For checking the accessibility of the cutting edge zone at the front ...
2024-12-09 17:12:04
|
|
...IEC60335, IEC 60529. Application It is used with the testing probe for the convenience and correctness. In the two output electrodes, the low ...
2024-12-09 12:18:12
|
|
... test probe C and IEC60529 for IP3 and suffix C codes. It is used to verify the protection of persons against access to hazardous parts, also used ...
2024-12-09 22:22:38
|
|
.... As required in the standards, it is used to test the mechanical integrity of product enclosures. After applying the impact with the hammer, the ...
2024-12-09 10:47:48
|
|
IP Testing Equipment Test Probe A Made of Nylon Handle and Steel Ball IEC60529 IP1 Product introduction for IP Testing Equipment: This probe is ...
2024-12-09 22:22:12
|
|
...test conforms to the standard requirements of IEC60068-2-63,IEC60068-2-75,IEC60335 and IEC60598. As required in the standards, it is used to test ...
2024-12-09 10:47:48
|
|
...correctness. In the two output electrodes, the low potential (the red one) is connected with the energized part of the electrical appliance and the ...
2024-12-09 10:47:48
|