231 - 240 of 393
fire hazard testing machine
Selling leads
|
... provision to apply the force 0~ 75N with minimum resolution of 5N provided with banana pin at back side to check the continuity during the test. ...
2024-12-09 13:00:26
|
|
...ween the access probe and hazardous parts. For the test of first characteristic numeral 1 , the access probe 50 mm diameter shall not completely ...
2024-12-09 13:06:35
|
|
... 12.3 Acceptance conditions The protection is satisfactory if adequate clearance is kept between the access probe and hazardous parts. For the test ...
2024-12-09 13:07:58
|
|
...Test Finger Probe B With Baffle Diameter 125 mm Standard: IEC60335-2-14 IEC 61032 figure 2, IEC60950 figure 2A, IEC60884, UL507, and UL1278 figure ...
2024-12-09 13:11:32
|
|
...codes. It is used to verify the protection of persons against access to hazardous parts. Also it is used to verify the protection against access ...
2024-12-09 13:36:27
|
|
... safety standards for electrical equipment. The IEC standards reduce safety hazards that can occur from unpredictable circumstances when using ...
2024-12-09 17:50:58
|
|
... or sheath may burn. In many occasions (coal mine, ship, subway, etc.) that require strict prevention of fire, the flame shall not spread in case ...
2025-08-03 00:02:02
|
|
...test conforms to the standard requirements of IEC60068-2-63,IEC60068-2-75,IEC60335 and IEC60598. As required in the standards, it is used to test ...
2024-12-09 10:47:48
|
|
...Test Finger Probe Products information: This rigid finger probe conforms to the standard requirement of IEC61032 figure 7 device 11,IEC60884...
2024-12-09 10:47:48
|
|
...Test Finger Probe Products information: This rigid finger probe conforms to the standard requirement of IEC61032 figure 7 device 11,IEC60884...
2024-12-09 10:47:48
|