381 - 390 of 572
yokogawa relay input board
Selling leads
|
... The two inputs E 62,00 and E 62,01 can be assigned to the internal high-speed counter by configuration. If the counter is used and therefore ...
2024-12-09 12:04:32
|
|
... range equals the measuring range of the single channel. I.e. that the signals, related to AGND, at the two involved inputs must not exceed this ...
2024-12-09 12:04:32
|
|
...n disconnectinginductive loads (see figure). This is why the difference between UPx and the input signal may not exceed the clamp voltage of the ...
2024-12-09 12:04:32
|
|
...the input when disconnectinginductive loads (see figure). This is why the difference between UPx and the input signal may not exceed the clamp ...
2024-12-09 12:04:32
|
|
... if UP5 = 24 V, the input signal voltage must be between -12 V and +30 V. If UP5 = 30 V, the input voltage has to be within -6 V and +30 V.If all ...
2024-12-09 12:04:32
|
|
..., but with the following exception: Caused by the direct electrical connection with the output, the varistor for demagnetization of inductive loads ...
2024-12-09 12:04:32
|
|
... YPH108B/SPC ABB YPH108B/SPC Speed Measurement Board For new products Product Description: The input impedance is ca. 330 Ω. The current input has ...
2024-12-09 12:04:32
|
|
...BOARD DSDP New foreign imports Product Description: From the value of the channel with the higher address. The converted measured value is ...
2024-12-09 12:04:32
|
|
...Board FACTORY SEALED Product Description: From the value of the channel with the higher address. The converted measured value is available on the ...
2024-12-09 12:04:32
|
|
..., but with the following exception: Caused by the direct electrical connection with the output, the varistor for demagnetization of inductive loads ...
2024-12-09 12:04:32
|