Portable Lightweight Stainless Steel Tripod Telescopic Mast Pole
Specification
• The telescopic pole is manual lifting. There are two sections.
When you loosen the screw, you could control the Telescopic Pole
raised or down. When you tighten the screw, you could fixed height
of the mast.
• The manual telescopic is simple design. It doesn’t need many
accessories. Only need tripod and some screws. The accessories
could be provided. With the simple design, the mast is very easy to
operate. You can finish install it in a minute.
• The stainless steel telescopic mast is light weight. It is
very portable. You could easily take it out and use it on the
vehicle or ground.
• Okaf telescopic mast widely applied to Antenna, PTZ camera,
dome CCTV camera, led emergency lighting field. Tubes are made of
high tensile military degree stainless steel and all are
heat-treated Which again corrosion, rust and acid rain. So the mast
life time is longer.
Technical data of the Steel tripod telescopic mast:
| Lifting method | Manual |
| Extended height | 2.5m 3m 5m 6m7m customized |
| Retracted height | 1200mm |
| Number of Section | Section 4 |
| Horizontal and vertical rotation speed | 6r/min |
| The wind resistance | 19m/sec |
| The largest load | 3 KG |
| Material | High tensile stainless steel |
Environmental adaptability:
| project | Test conditions |
| The wind resistance | 8 wind working normally 12 wind does not destroy).3.13.13 GJB74A -
1998 |
| Low temperature storage | -55° |
| Work in low temperature | -40° |
| High temperature storage | 70 degrees |
| High temperature work | 65 degrees |
| Wet degree | Less than 90% (25 ° temperature) |
| Drench the rain | The duration of 6mm/min was 1h |
| Corrosion protection | Refer to gjb150.11a-2009 standard test |
| Sand dust | Refer to GJB150.12.1986 standard test |
| The sun's radiation | Refer to GJB150.7.1986 standard test |
