361 - 370 of 396
convex face dth drilling bits
Selling leads
|
Product Description: The hammer is an imperative element of DTH drilling tools. It changes over high-weight compacted air into a strong effect power, ...
2025-07-14 00:07:31
|
|
...rock formation. Different types of hammers are available, such as without valves, with valves and multi-speed hammers, all of which meet different ...
2025-07-14 00:07:31
|
|
... made in China, we produce all threaded button bits by hot press technology. A comprehensive range of various button bits shown as below: Thread ...
2024-12-09 12:11:48
|
|
... Weight (less bit) 487kg (1071lbs) Hole range 305mm-445mm Working pressure 10-25bar Impact rate at 1.7 Mpa 16Hz Recommended rotation speed 15-25 r...
2024-12-09 12:11:40
|
|
... 3 1/2" REG pin Weight (less bit) 100kg Hole range 155mm-203mm Working pressure 10-35bar Impact rate at 1.7 Mpa 23Hz Recommended rotation speed 20...
2024-12-09 12:11:40
|
|
...Drilling Product APPLICATION: DTH hammers and bits are widely used in underground mining, quarries, hydraulic and Hydro-Power Engineering, water ...
2024-12-09 12:33:51
|
|
OD82mm DHD3.5 Down Hole Hammer For Water Well Drilling Product introduction: Down-the-hole rock tools (drilling tools) are rock drilling equipment ...
2024-12-09 13:08:23
|
|
...good drilling performance and long service life. They are with high efficiency, low failure rate and long service life. Even for all kinds of high ...
2024-12-09 12:40:32
|
|
... The R.C.System collects sample through the recovery holes in the face of the drill bit immediately as the cutting orsample is formed.The drilled ...
2024-12-09 12:11:48
|
|
...drill bit immediately as the cutting orsample is formed.The drilled sampledoes not have to travel the length of the hammer where contamination and ...
2024-12-09 12:11:48
|