11 - 20 of 70
go gauge no go gauge
Selling leads
|
...Gauges for Lampholder Lampcap and Bases with CNAS Certificates 1. Introduction Lamp cap and Lampholder Gauges are designed according to IEC60061-3, ...
2025-07-09 00:09:13
|
|
...Gauges E40, E39, E12, GX53 with Calibration Certificates 1. Introduction Lamp Cap Go Not Go Gauges are designed according to IEC 60061-3, which ...
2025-07-09 00:09:13
|
|
...finished lamps. Testing: caps on finished lamps shall be assured to be correct if the gauge does not pass over the cap by its own weight. “Go” ...
2025-07-09 00:09:13
|
|
IEC60061 - 3 G5 lamp Cap Gauge Go Not Go Gauge 7006 - 46A and 7006 -46 with CANS Certificate Go Gauge for Bi-pin Cap on Finished Lamps G5 (7006-46A-3) ...
2025-07-09 00:09:13
|
|
...t for use on finished lamps) G5 7006-46-3 "Go" gauge for bi-pin cap on finished lamps G5 . 7006-46A-3 Plug gauge for lampholders for testing ...
2025-07-09 00:09:13
|
|
...Gauges for Lampholder Lampcap and Bases with CNAS Certificates 1. Introduction Lamp cap and Lampholder Gauges are designed according to IEC60061-3, ...
2025-07-09 00:09:13
|
|
... and dimension T1 minimum of E40 caps on finished lamps. Testing: When the cap in a finished lamp has been screwed into the gauge as far as it will ...
2025-07-09 00:09:13
|
|
... thread and dimension X shown on sheet 7005-20. Testing: It shall be possible to screw the gauge into the lampholder without using undue force. ...
2025-07-09 00:09:13
|
|
...Gauge for E17 Lamp Cap Gague Conforms to IEC60061-3 Introduction: E14 lamp cap and lampholder gauges are designed according to IEC60061-3:2004, ...
2025-07-09 00:09:13
|
|
IEC60061 - 3 GU10 Lamp Cap Gauge Go Not Go Gauge for bases 7006-121-1 GU10 “Go” and “Not Go” Gauge for bases 7006-121-1 Purpose: To check the base ...
2025-07-09 00:09:13
|