PLC Control IP Testing Equipment IP01 / IP02 Dripping Water Resistance Environment Tester
|
IP01 / IP02 Dripping Water Resistance Environment Test Equipment PLC Control
1. Introduction
2. Testing Method Instruction 2.1 IPX1 Testing Method 2.1.1 Connect the water inlet and power well 2.1.2 Press the power switch “ON” to start the device 2.1.3 Open the tap 2.1.4 Find the “WATER MAGNETIC VALVE” button in the “MANUAL” interface, press it to make the drip board full filled with water, and open the control valve of flowmeter to max. to fill tank’s water, observe all the needle tip dropping water means the drip board is fulled with water, then turn down the control valve of the flowmeter to 1L/min of IPX1, close the inlet valve switch. 2.1.5 Put the sample in the turntable base, and adjust the turntable’s height to make the sample enclosure’s top 200mm far away from needle tip. 2.1.6 Enter into the “IPX1/2 AUTO” interface, press the “START” button to begin test 2.1.7 Finished test, turn off the power.
2.2 IPX2 Testing Method 2.2.1 Find the “WATER MAGNETIC VALVE” button in the “MANUAL” interface, press it to make the drip board full filled with water, and open the control valve of flowmeter to max. to fill tank’s water, observe all the needle tip dropping water means the drip board is fulled with water, then turn down the control valve of the flowmeter to 3L/min of IPX2, close the inlet valve switch. 2.2.2 First adjust the turntable to 15°, then put the sample in the turntable base and adjust the turntable height to make the sample enclosure’s top 200mm far away from needle tip. 2.2.3 Enter into the “IPX1/2 AUTO” interface, press the “START” button to begin test 2.2.4 Finished test, turn off the power.
3. Picture
4. Third-Lab Calibration Certificate
|
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Product Tags: waterproof test equipment water ingress test equipment |
![]() |
Hole Diameter 0.5mm Aluminum Baffle IPX3/IPX4 Ingress Protection Testing Hand-Held Spray Nozzle IEC60529 Clause 14.2.3/14.2.4 |
![]() |
IEC60529 Clause 14.2.9 Figure 10 IPX9K High Pressure and Temperature Water Jetting Ingress Protection Testing Machine |
![]() |
IEC60529 Clause 14.2.3 and 14.2.4 Figure 4 Ingress Protection Testing Machine for IPX3 and IPX4 Waterproof Testing |
![]() |
IEC60529 Ingress Protection Testing Machine for IPX1 and IPX2 Vertical Drip Test |
![]() |
IPX5 and IPX6 Jet Nozzle Ingress Protection Testing Machine for IPX5 and IPX6 Testing Standards |
![]() |
IEC61851-1 Standard Test Finger For Verifying Accessibility To Live Parts Of Vehicle Connector |