1 - 10 of 58
20ma analog voltage isolator
Selling leads
|
...Ω Output Output signal: 4-20mA; 0-20mA; 0-5V; 0-10V Output load resistance: RL≤500Ω (when output is current signal); RL≥10KΩ (when output is ...
2024-12-09 19:12:27
|
|
...load resistance: RL ≤ 800Ω (output is current signal); RL ≥ 1MΩ (output is voltage signal) Output ripple: ≤10mVp-p Basic parameters Number of ...
2024-12-09 18:44:27
|
|
...20mA Wireless Analog I/O module 2km wireless control 2AI and 2AO Introduction LS-RAI02 Modbus RTU is a 1W analog input module, 2 analog inputs, 1 ...
2024-12-09 18:32:12
|
|
33MHz 2km Remote I O Module Control RS485 Connect PLC 2AI Collect 4-20mA Analog Signal 2DO Advantage of wireless solution No wires to bury or maintain...
2024-12-09 18:15:15
|
|
... Pump Controller Remote Control Pump ON-OFF accoding Water Level On tank side, we use a wireless analog I/O module to collect the level sensor's 4...
2024-12-09 18:45:38
|
|
LS-RAO02-Lora wireless analog acquisition module LS-RAO02-Lora Modbus RTU is a 1W I/O module, 2 analog outputs. Wireless control around 5km LOS. Use ...
2024-12-09 18:15:15
|
|
...analog input distribution isolator, is to provide isolation power for two-wire transmitters and three-wire transmitters on site, and also ...
2024-12-09 19:08:14
|
|
... signal produced by the transmitter. It needs independent power supply. Its power supply, input and output are separated to each other. Input Input ...
2024-12-09 18:51:25
|
|
...voltage (maximum range 0-10V); millivolts (maximum range 0-100mV); Current source (4- 20mA); transmitter (distribution), current 4-20mA; resistor, ...
2024-12-09 18:35:34
|
|
...Analog Current or Voltage Signal Converters, D/A Converter Output is 1 channel voltage/current signal, or 2-channel common ground current/voltage ...
2024-12-09 18:44:27
|