Perfect Fitting Active Carbon Face Mask Single Use multi - layers Ce Approval

CE FFP1 Valved Respirator Mask ,Activated Carbon Dust Mask ,Non-Woven Polypropylene

1 . Material of each layer

• EN149: 2001 +A1: 2009. Respiratory protective devices. Filtering half masks to protect against particles. Requirements, testing, marking.It complies with European Regulation (EU) 2016/425 on Personal Protective Equipment (PPE).Category III.
• EU type examination certificate (module B) issued by BSI , notified body n°0086.The PPE is subject to the conformity assessment procedure based on internal production control plus supervised product checks at random intervals (Module C2) set out in Annex VII under surveillance of BSI , notified body n°0086.

Outer layer : Protective pp spun-bonded non-woven 

Middle layer : FFP2 melt blown filter(have filter efficiency level of 80%)

Middle layer :Active Carbon filter (MX-2008)

Inner layer : Shaped needle punched cotton

2 . Descriptions

MX-2008 FFP1V Dust Mask with two head-straps provides comfortable & secure seal,nose clip individually adjustable nose clip for excellent fit.

In compliance with the norm EN 149:2001+A1:2009 ,PPE III CATEGORY and Shell-shaped

3 . Mask CE Quality Standards

4 . How to use?

• The mask is for single use only.
• The mask should not be removed from its packaging until its required for use.
• Use the respirator in accordance with applicable health and safety regulations.
• Fit the respirator and check leak-tightness before entering the contaminated area.
• Wear the respirator for the whole duration of exposure to contaminants.It should not be used for more than 8 hours continuously and should be discarded after use.
• Transport and stockage of unused masks should be such that the product is not stored in direct sunlight and in frost free conditions,not in contact with solvents and cannot be damaged by physical contact with hard surfaces/items.
• As required by European Health and Safety requirements,the user is advised that when the mask is in contact with the wearer’s skin,it may cause allergic reaction to susceptible individuals.If this is the case,leave the hazard area,remove the mask and seek doctor’s advice.​

5. Warning

• The user should be trained in the fitting and should be aware of the instructions for using prior to donning the respirator.
• Use in adequately ventilated areas,which are not deficiency of oxygen.
• Do not use this respirator when oxygen concentration is less than 19.5%.
• Do not use the mask in explosive environment.
• The mask must be fitted correctly to ensure the level of protection expected is achieved.
• The facila hairs or heards and certain facial charactrtistics may reduce the effectiveness of the mask.
• For mask mark marked “NR”,the particle filtering half mask shall not be used for more than one shift.

6 . More pictures