Portable High Speed Dental Handpieces Air Turbine 10.8mm

Henan Dorit Biotechnology Co., Ltd. always takes “quality bearing responsibility, technology creating advantage, innovation leading the future ” as its development concept, and conscientiously implements to the operation, management, product research and development and manufacture. Henan Dorit specialize in dental treatmen equipment area, main product contains high or low speed dental handpiece, ultrasonic scaler, three-way syringe and Dental LED Curing light.

During the process of serving global oral industry , Dorit takes every step as walking on the thin ice. We not only innovate bravely, but also go ahead steady step by step. During the process of serving global oral industry , Our products have been bought in more than 100 countries abroad, such as the United States, Germany, Canada, Mexico, Brazil, Vietnam, Sri Lanka, Iraq, etc., and are well received by customers.

Our target is“share wealth with the world;Soul moisten in the dental profession” We are adhering to the company’s mission "Quality assurance is the responsibility, Technology is the advantage, Innovation leads the future", and implement these philosophies to the company’s management, product R & D and manufacturing. Dorit Company continues to absorb high-grade, precision and advanced talents to integrate related industry resources in order to offer better and more comprehensive services to the society.

After each patient use , maintenance should be done as follows:

1. First remove the diamond burs , and clean up all the teeth on dental handpieces precipitate

2. Use a metal needle to clean the spray holes and fumaroles

Note: The spray holes and diamond burs into 40 -degree angle , fumaroles and diamond burs to a 30 degree angle

3. Place the clean lubricating oil is sprayed into the axial hole 1-2 seconds ( diamond burs is plugged holes )

4. In the bottom of the handpiece were ( with / without quick connector ) two kinds of styling , make the right amount of lubricant is injected into the bottom

5. The handpiece with quick connector combination ( first determine the water switch is turned off )

6. Replace the diamond burs , surrounded by white silk cloth handpiece head ( make sure the needle does not touch the diamond burs and white gauze , so as not to tie )

7. pedal depressed for about 20 seconds , look at whether there is in white gauze on any stain. If there are stains on the white gauze , again, add oil , starting from item 4 continued routine maintenance , know that white gauze until no stain

8. Finally, no more than 135 degrees Celsius temperature and high pressure sterilization

Instruction:

After each treatment,Sterilizing handpiece in autoclave according to the following steps:

1.Remove the bur and brush clean handpiece, clean outside of handpiece with an alcohol solution.

2.Lubricate handpiece, each times drop two drops inside of air inlet pipe.

3.Place into autoclaving pouch and mark.

4.Autoclave the handpiece for 12 min. at 135ºC.