91 - 100 of 204
auto hydraulic butt fusion welding machine
Selling leads
|
... cutter and take out the milling cutter. The chip thickness should be about. If the depth of the scar exceeds 10% of the wall thickness of the pipe...
2025-05-16 14:17:25
|
|
... lift the handles on both sides during transportation.When transporting the rack, make sure that the chucks are all tightened to prevent them from ...
2025-05-16 14:17:25
|
|
...nonstick layer on the surface of the heating plate),the gap between the two ends of the pipe should not exceed 10% of the wall thickness, otherwise ...
2025-05-16 14:17:25
|
|
... to this component, follow the relevant requirements of this manual, such as Instructions for Use Butt Fushion Welding Machine Technical data: item ...
2025-05-16 14:17:25
|
|
...pipe should not exceed 10% of the wall thickness.The part outside the frame of the pipe shall be supported by supports to reduce friction, and then ...
2025-05-16 14:17:25
|
|
Hydraulic butt welding machine SHT250-SHY tube welding machine 1. Suitable for welding of plastic pipes and fittings made of HDPE PVDF and MPP, and ...
2025-06-20 00:13:44
|
|
63mm-160mm 4 Clamps HDPE PIPE manual Butt Fusion Welding Machine 1. Suitable for welding of plastic pipes and fittings made of HDPE PVDF and MPP, and ...
2025-06-20 00:13:44
|
|
63mm-160mm 2 Clamps HDPE PIPE manual Butt Fusion Welding Machine Product description 1. The raw material of the machine frame is aluminum , it is ...
2025-05-16 14:17:25
|
|
...Fusion Welding Machine Price List SHT250-2/4(A) Using the hydraulic pressure on the system, the two pistons on the carrying metal bars move the ...
2025-05-16 14:17:25
|
|
...Fusion Welding Machine SHT200-2/4(A) The machine is used to weld pipes made from PE, PP, PVDF and cannot be used to weld material without ...
2025-05-16 14:17:25
|