171 - 180 of 220
wireline tool string calibration sub
Selling leads
|
... falling into the well when the tool string is lifted out. It is installed below the blowout prevention pipe and above the blowout prevention valve...
2024-12-09 22:39:11
|
|
... pressure. When multiple wireline runs are required, the lubricator has to be tested each time the bottom connection is broken, and much time can ...
2024-12-09 13:22:13
|
|
...Wireline Fishing Tool I. Overview: GO Devil Flat Bottomed are used to cut stuck tool string wires. Flat bottom wire cutters consist of a solid rod ...
2024-12-09 13:48:14
|
|
... O.D. should be selected very close to the I.D. of the tubing in which it is run. It should be used prior to running or pulling a subsurface ...
2024-12-09 13:22:13
|
|
...end is connected to the anti-uplifting tool. When dropping the downhole tool, the lower joint of the hand-off tool is connected with the anti...
2024-12-09 13:34:00
|
|
... and angular offset provided by the Wireline Knuckle Joint can facilitate the operation when the hole is limited and the operation is in a branch ...
2024-12-09 22:39:11
|
|
... string and the lower end connected with the anti-upward movement tool. When putting in the downhole tool, the lower joint of the unlatching tool ...
2024-12-09 13:27:40
|
|
...Sub Wireline Pressure Control Equipment 5K Wireline Quick Test Sub Wireline Pressure Control Equipment Ⅰ. Introduction During Wireline operations ...
2024-12-09 13:22:13
|
|
...Wireline Pressure Gauge Hanger I. Overview: The unlatching tool is a tool for putting in downhole instruments, with the upper end connected with ...
2024-12-09 13:30:01
|
|
...Sub 5K Wireline Pressure Control Equipment Ⅰ. Introduction The Quick Test Sub is designed to save drilling time while pressure testing the ...
2024-12-09 13:44:16
|