Mindray IMEC8 Patient Monitor parts 8'' Touch Screen With 4 Wire Line

Mindray IMEC8 Patient Monitor 8” 4 Wire Line Touch Screen

Mindray IMEC8 Patient Monitor 8”Touch Screen With 4 Wire Line

Touchscreen and Touchscreen Control Board

Fully configured iMEC patient monitor supports touch screen.

The touch screen can be controlled and calibrated by touch. The touch screen is connected to the touch screen control panel and the motherboard.

The touch screen control panel controls the touch screen and communicates with the monitor. The touch screen control board communicates with the motherboard through I2C interface and connects to the touch screen through FPC

Touchscreen Calibration

1.Select [Main Menu]→ [Maintenance >>] → [Cal. Touchscreen].

2.The  symbol will appear at different positions of the screen.

3.Select, in turn, the central point of the symbol

4. After the calibration is completed, the message [Screen Calibration Completed!] is displayed. Select [Ok] to confirm the completion of the calibration.

Troubleshooting

Specification Of Mindray IMEC8 patient monitor 8” touch screen

Removing the Touchscreen Control Board (Optional)

Loose and unscrew the two M3X8 screws as shown below. Disconnect the touchscreen cable and cable for touchscreen control board, and then

remove the touchscreen control board

Removing the Touchscreen (Optional)

Unscrew the ten M3X8 screws indicated below. Take out the touchscreen bracket and then the touchscreen

Disassembling the Screen

1. Unscrew the ten M3X8 screws indicated below. Then take out the screen bracket.

2. Unscrew the four M3X8 screws indicated below to remove the screen

Thank you so much for your attention .If you're interested in  Mindray IMEC8 Patient Monitor 8” 4 Wire Line Touch Screen ,feel free to contact us .Thank you .