PHiliph MP60 MP70 Patient Monitor Module Rack Bedside M8048A FMS-8

M8048A FMS-8 PHiliphhilip MP60 MP70 Patient Bedside Monitor Module Rack

PHiliphhilip FMS module rack

MAX weight:<3500g ,<7.7 lb

Weight*Height *Width:<315mm*130mm*120mm (12.4*5.1*4.7inch )

Flexible Module Server Troubleshooting

PHiliphhilip FMS/MMS Module Lock

The following parts and hardware are included in this mounting kit

Mounting Notes: The bracket is designed to accommodate FMS (handle on both ends) or MMS extension (handle on one end). Installation is only shown on FMS with MMS extension.

Installing the Module Lock

1. After installing the required modules, slide the FMS into the main housing as shown below. Installation Note: It is not necessary to remove the previously installed mounting clips from the FMS to install the module lock.

2.Slide the support bracket over the MMS extension and into the main housing as far as it will go. Note the slot on the bracket for mounting the module lock on the second handle.

3.Using the 5/32'' tamper-resistant hex key provided, install four (4) #8-32 x 1/4'' tamper-resistant screws as shown below.

Installation Notes: Module locks are designed to provide space for individual modules to be disconnected without removing them from the server.