- ARUBA 207 SERIES ACCESS POINTS
- Brand new Aruba JX954A IAP-207(RW) Wireless Access Point AP JX954A
in stock ready to ship
- AP type: Indoor, dual radio, 5GHz and 2.4GHz 802.11ac 2x2 MIMO
- WIRELESS RADIO SPECIFICATIONS
• AP type: Indoor, dual radio, 5-GHz 802.11ac and 2.4-GHz 802.11n
2x2:2
• Software-configurable dual radio supports 5 GHz (Radio 0) and 2.4
GHz (Radio 1)
• 2x2 MIMO with two spatial streams and up to 867 Mbps(80-MHz
channel) or 400 Mbps (40-MHz channel) wireless data rate
• Support for up to 255 associated client devices per radio,and up
to 16 BSSIDs per radio
• Available channels: Dependent on configured regulatory domain
• Dynamic frequency selection (DFS) optimizes the use of available
RF spectrum
• Supported radio technologies:
--802.11b: Direct-sequence spread-spectrum (DSSS)
--802.11a/g/n/ac: Orthogonal frequency-division
• Advanced Cellular Coexistence (ACC) minimizes interference from
cellular networks
• Maximum ratio combining (MRC) for improved receiver performance
• Cyclic delay/shift diversity (CDD/CSD) for improveddownlink RF
performance
• Short guard interval for 20-MHz, 40-MHz and80-MHz channels
• Space-time block coding (STBC) for increased range andimproved
reception
• Low-density parity check (LDPC) for high-efficiency
errorcorrection and increased throughputTransmit beam-forming
(TxBF) for increased reliability in signal delivery
• Supported data rates (Mbps):
--802.11b: 1, 2, 5.5, 11
--802.11a/g: 6, 9, 12, 18, 24, 36, 48, 54
--802.11n: 6.5 to 300 (MCS0 to MCS15)
--802.11ac: 6.5 to 867 (MCS0 to MCS9, NSS = 1 to 2)
• 802.11n high-throughput (HT) support: HT 20/40
• 802.11ac very high throughput (VHT) support:
--PoE-PD (input): 48 Vdc (nominal) 802.3af/at PoE
• Local: Three 10/100/1000BASE-T Ethernet (RJ-45, bottom)
--Auto-sensing link speed and MDI/MDX
--802.3az Energy Efficient Ethernet (EEE)
--One port: PoE-PSE (output): 48 Vdc (nominal) 802.3af PoE
• Passive pass-through interface (two RJ-45, back and bottom)
• USB 2.0 host interface (Type A connector)
--Aruba Beacon USB radio module
--3G/4G cellular modems
--Device battery charging port
--Capable of supplying up to 1A/5 watts of power to an attached
device
• DC power interface, accepts 1.35/3.5-mm center-positive circular
plug with 9.5-mm length
• Visual indicators (LEDs):
--Power/system status
--PoE-PSE status
• Reset/LED control button (“paperclip access”)
--Factory reset (when activated during device power up)
--LED control: toggle off/normal
• Serial console interface (custom, four-pin header)
• Kensington security slot
POWER
• Direct DC source: 48 Vdc nominal, +/- 5%
• Power over Ethernet (PoE): 48 Vdc (nominal) 802.3af/at
compliant source
• Power sources sold separately. Recommended Aruba
part numbers:
--DC: AP-AC-48V36 (48V/36 watts)
--PoE: PD-9001GR-AC (802.3at)
• When both power sources are connected and active, DC power takes
priority
• Power modes:
--DC: unrestricted mode (USB: 5 watts max, PoE-PSE: 15.4 watts max)
--802.3at PoE: reduced mode (USB disabled when PoE-PSE enabled,
PoE-PSE reduced power budget:
10 watts max)
--802.3af PoE: restricted (USB and PoE-PSE disabled)
• Maximum (worst-case) power consumption:
--DC: 12 watts max, plus 16.5 watts max for PoE-PSE and 5.5 watts
max for USB
--802.3at PoE: 13 watts max, plus 11.5 watts max for PoE-PSE or 6
watts max for USB
--802.3af PoE: 13 watts max
• Maximum (worst-case) power consumption in idle mode (excluding
PoE-PSE, USB): 7.5 watts | RF PERFORMANCE TABLE | | | Maximum transmit power (dBm)
per transmit chain | Receiver sensitivity (dBm)
per receive chain | | 2.4 GHz | | 802.11b | | 1Mbps | 18.0 | -90.0 | | 10Mbps | 18.0 | -90.0 | | 802.11g | | 6Mbps | 18.0 | -90.0 | | 54Mbps | 18.0 | -75.0 | | 802.11n HT20 | | MCS0/8 | 18.0 | -90.0 | | MCS/7/15 | 18.0 | -71.0 | | 802.11n HT40 | | MCS0/8 | 18.0 | -87.0 | | MCS7/15 | 18.0 | -68.0 | | 5 GHz | | 802.11a | | 6Mbps | 18.0 | -90.0 | | 54Mbps | 17.5 | -75.0 | | 802.11n HT20 | | MCS0/8 | 18.0 | -90.0 | | MCS7/15 | 17.0 | -71.0 | | 802.11n HT40 | | MCS0/8 | 18.0 | -87.0 | | MCS7/15 | 17.0 | -68.0 | | 802.11ac VHT20 | | MCS0 | 18.0 | -90.0 | | MCS8 | 16.0 | -67.0 | | 802.11ac VHT40 | | MCS0 | 18.0 | -87.0 | | MCS9 | 15.0 | -65.0 | | 802.11ac VHT80 | | MCS0 | 16.0 | -84.0 | | MCS9 | 15.0 | -65.0 |
- We have the overall comprehensive strength of software development,
design implementation, and consulting services. The company has
cultivated an excellent technical research and development,
management, marketing and service team. From information
infrastructure system construction to application software system
development, from project blueprint planning to after-sales
operation and maintenance, we provide closed-loop overall packaging
services. Provide customers with one-stop digital construction
integration services.
FAQ Q1.What can you buy from us? A:Mellanox, Aruba, Rukus, Extreme brand
products, including switches, network cards, cables, Access Point,
etc. Q2.How about the delivery date? A:It usually takes 3-5 working days. For
specific models, please contact us to check the stock. In the end,
the actual
consultation shall prevail. We will do our best to deliver as
soon as possible. Q3.What's your warranty terms? A: We supply 12 months warranty time. Q4.How about the Shipping Method? A: We use Fedex/DHL/UPS/TNT and other air
shipments,sea shipments are also workable. In one words, we could
do any shipments that you wanted. Q5.Can I get some samples? A:Yes, sample order is available for quality
check and market test. You only need to pay the sample cost and
express cost. Q6.What are your core strengths? A:First-hand supply, Original and new products
with the favorable price and perfect after-sales service.
|
