Round Bar Tube Chamfering Machine 80 Single Head Deburring End Angle Facing Smoothing

Features on Pipe Chamfering Machine

1. A circular tube modifies an interior angle,an external angle and flat plane at one time with fastness and precision.
2. Automatic and manual working mode which are convenient for adjusting the machine,mold and chamfering knife.
3. Material Available: Carbon Steel,Stainless Steel,Copper,Aluminum...
4. Each process of chamfering work is driven by pneumatic.
5. Clamp device and knife holder are precisely designed for ensure the center line between workpiece and knife holder at the same level.
6. Dual Feed Chamfer system:
7. First speed------Fast forward movement nearly to tube end to save the time.
8. Second speed---Infinitely variable forward adjustable Chamfering speed to get smooth finish.
9. Good mechanical parts ensure machine runs in high stability.

1.Machine's information

1. Power supply: start the motor and see if the steering is correct;

2. Air supply: see if the air pressure of the filter and pressure gauge reaches 4-5kgf/cm2

3. Check whether the clamping die meets the specifications of pipes and bars.

4. Install the correct blade on the knife holder of the cutter head. The square type is a flat knife, and the triangle type is an inner and outer knife. Please don't install it wrong. Cutter heads of different specifications are used in the direction of forward rotation, plane, outer corner, inner corner, and different materials.

5. Adjust the position of the knife, loosen the screw of the knife holder, adjust the upper and lower screws of the knife holder, and adjust the outer angle outward to be larger than the outer diameter of the tube or bar, and adjust the inner angle inward to be smaller than the inner diameter of the tube. End face.

6. Put the work piece in the fixture until the stopper is enough, go to manual → clamp material → start motor → feed, and the processing is completed. Feed the knife again and adjust the tool position until the machining standard. Make sure to tighten the screw of the knife holder each time before starting the motor. After debugging, make sure that the switch arrow points to retract→retract, and then auto can be turned on.