Universal Type Solvent Based Bonding Agent with Strong Adhesion for CPU Roller

Universal Type Adhesive Bonding Agent for Polyurethane CPU Roller

It is the bonding agent for CPU roller.

• State: liquid
• Shelf life: 24 months

• Universal applying and can be used for various skeletons
• Strong adhesion ability

1. Prepare the metal surface properly by removing completely oil, grease and dirt.
2. Blasting the surface with grit blasting steel so that the surface roughness is greater than 15 µm.
3. For aluminum surfaces we recommend the use of aluminum oxide as abrasive.
4. Clean again the substrate to remove dust from blasting residues.
5. If specified, the metal part can be phosphatized, galvanized, chromate conversion treated or KTL, before applying adhesive.

Agitation: We recommend stir Thinkbond adhesive before the application to avoid settle down.

Brushing: Application by brushing is normally undertaken without further dilution, but for coating large areas, dilution with MEK (or the diluent blend shown below) improves flow and speed of application.

Spraying: We recommend an HVLP gun using 1.5 Bar air-pressure and a nozzle size of 1 -1.5mm. For this application we recommend diluting between 50 and 100% v/v.

Roller coating: Dilute to 35 - 45 seconds on a DIN 4 or Ford 4 cup at 25°C for most roller application processes. Dilution with a high boiling solvent like MPA may be necessary to achieve the best finish and to reduce the skinning of the bonding agent in the applicator.

Drying: Dry the film between 10 and 30 minutes at room temperature. If it is necessary to reduce drying time, we recommend to use forced air for 5 minutes at 100ºC maximum. Do not use in this stage temperatures above 100ºC to avoid adhesive pre-cure. After this process, follow to cure.

Thickness of application layer: The layer thickness must be between 15 and 25 µm. For severe environments or dynamic fatigue applications, use ≧25 microns. Under these conditions it is possible to achieve bonds with no edge-failure after 400 hour salt-spray tests. Parts with Thinkbond adhesive already applied can be stored for 30 days prior to cure.

Storage: Keep container tightly closed during storage and always keep away from heat sources. Store in an environment below 10ºC increases the shelf life of the adhesive.