Semi Permanent Composite Mold Release Agents 1 Gallon For Wind Power Blade
|
Semi-Permanent High Brightness Mold Release Agent for Wind Power Blade
Application Field:
It is a special release agent for wind power industry -
semi-permanent, high brightness, no migration, mold cleaning, does
not affect the secondary processing of products.
Advantages:
Application: The mold should be thoroughly cleaned. Mold cleaning and release agent application should be performed in
a well ventilated area. 1. Apply Lubekote release agent to clean, dry cotton cloth. 2. Gently wipe over mold surface covering an area of approximately
0,5 m². Vigorous rubbing or polishing is not required. 3. Repeat steps 1 and 2 on the adjacent area. Ensure a good overlap
with the previous area to provide complete coverage 4. Repeat until mold is completely coated. 5. When dry, allow a further 15 minutes between coats for the film
to cure. 6. Repeat Steps 1- 5 above for a further 3 coats (4 in total). 7. When dry, allow final film to cure for at least 30 minutes at
room temperature before molding. Allowing a longer cure or heat
curing (e.g. 15 min. at 60 °C) will improve film durability Reapply one coat of Lubekote release agent in the same way as
described above when release becomes hesitant. Handling precautions:
Shanghai LoreChem Co., Ltd. was established in 2008. It is a
high-tech enterprise which is dedicated to serve releasing products
which involve semi-permanent release agent, anti-sticking, surface
lubrication and thermal reactive adhesive. Shanghai LoreChem has
been improving product quality for 15 years. The releasing products
are mainly applied in rubber, polyurethane and composite industry.
The brand of Lubekote for release agent and Thinkbond for adhesive
have been registered in China. Both of them are well known in the
industry.
|
|||||||||
Product Tags: 1 gallon composite mold release agents wind power industry mold release agents no migration composite mould release agent |
![]() |
Water-Based Forging Release Agent for Aluminum Die Lubrication |
![]() |
Water Based Release Agent for Battery Case STM Molding Process |
![]() |
Release Agent for Unsaturated Resin Bathroom Washbasin |
![]() |
High Temperature Composite Release Agent , Pltrusion Internal Mold Release Agent |
![]() |
Semi Permanent Composite Release Agent For Epoxy Polyester Vinyl Resin |
![]() |
Internal Composite Release Agent For Epoxy Resin Pultrusion Water Based |