Operation Details of Fully Automated Numerical Control Industrial Sheet Metal Special Brazing Machine:
1. Pre-operation Preparation
Check whether the appearance of the equipment is intact and whether there are any damaged or loose components.
For example: Check whether the power cord is damaged and whether there are cracks in the welding machine shell.
Ensure that the working environment is clean, well-ventilated, and free of flammable and explosive items.
Like cleaning up the debris in the working area to ensure that there are no flammable liquids or gases around.
Connect the power supply and check whether the electrical system of the equipment is normal.
You can observe whether the indicator lights on the equipment control panel are lit normally.

2. Parameter Setting
Set appropriate welding parameters in the numerical control system according to the sheet metal material to be welded and process requirements.
For example: Welding temperature, welding time, welding pressure, etc.
For example: For thinner sheet metal, the welding temperature can be set at a lower value.

3. Clamping the Workpiece
Correctly install the industrial sheet metal workpiece to be welded on the fixture to ensure its position is accurate and stable.
For example: Use a special fixture to fix the sheet metal workpiece to prevent displacement during the welding process.

4. Start the Equipment
After confirming that all preparations are completed, press the start button and the equipment starts to operate.

5. Monitoring during Welding
During the welding process, closely observe the welding situation.
For example: Observe the forming quality of the weld seam and whether there are defects such as pores and slag inclusion.
If any abnormality is found, press the emergency stop button in time and carry out corresponding treatment.

6. Completion of Welding
After the welding is completed, the equipment stops running automatically.
Carefully remove the welded sheet metal workpiece and place it in the designated position.

7. Equipment Shutdown
Turn off the equipment power supply.
Clean the working area and do a good job in the daily maintenance and upkeep of the equipment.

The above operation details are for reference only. The specific operation should be carried out according to the actual situation of the equipment and relevant safety regulations.