Portable Double Shooter Remote Control Safe Cable Piercing Cable Spiker

Working description
For the cable spiker, a single shooter can only produce one short circuit point on the cable at a time, and a double shooter can produce two short circuit points on the cable at a time. Since the three-phase cable is usually in the shape of a "品", if a single shooter is pierced, it will just pierce in the gap of the "品" (that is, the gap between the two phases) without penetrating the entire cable. Existence cannot create a real short circuit, that is, it cannot achieve the purpose of stabbing. It is recommended to use a dual shooter configuration. When the included angle of the dual shooters is not 120°, at least one shooter can achieve the purpose of stabbing and form a short circuit point.

Product Features
1. When the angle between the two shooters is not 120°, at least one shooter can achieve the purpose of piercing and form a short circuit point;

2. It adopts wired + wireless remote control, and can be remotely controlled through a wall;

3. It can be used for both AC and DC, with a built-in lithium battery pack and a large-capacity energy storage device, and has a long charging time;

4. It is small in size and light in weight, very suitable for outdoor use.

Operation interface introduction

1. Grounding: grounding point of the instrument, safety protection;

2. Output 1: used to connect to the shooter body;

3. Output 2: used to connect to the shooter body;

4. Charging: DC12V charging port, connect to a 12V charger to start charging;

5. Switch: turn on/off the working power;

6. Indicator light 1: when output 1 is working, the indicator light is on;

7. Indicator light 2: when output 2 is working, the indicator light is on;

8. Power indicator: when the built-in battery is working, it indicates the battery power in real time.

Field wiring

Packing list

1. Controller: control the shooter to carry out the cable puncture action process;

2. Remote control: The two buttons (A.B) of the remote control correspond to output 1 and output 2 of the controller;

3. Bullet: Loaded into the chamber when stabbing;

4. Nails: put them into the nail tube when stabbing;

5. Shooter

6. Output line: the connection line between the controller and the shooter;

7. Ground wire: the connection wire between the shooter and the ground drill;

8. Ground drill: Generally, there is no formal grounding point on site, so find a reliable ground to insert;

9. Screwdriver, socket, test tube brush: accessories for cleaning the shooter;

10. Power cord (charger): Control box charging cable.