GSCJ-8301B1 SMT PCB Magazine Loader And Unloader Rack PCB Circuit Board Rack

Installation Guide

1. Install the Rack: Ensure the rack is aligned and flush with the base plate.

2. Secure the Columns: Use screws to fix the four columns firmly.

3. Attach the Side Panel: Align the holes and tighten the screws.

4. Position the Movable Side Panel: Ensure the bottom edge is close to the rack.

5. Install the Base Plate: Push the circular pin of the latch upward and move the side panel.

6. Install the Stopper: Attach it at the spring position, facing downward.

Special Note: Pay attention to steps 4 and 5. The circular pin of the latch must align precisely with the circular hole on the base plate. Accurate positioning is crucial to avoid misalignment; ensure synchronization in all directions.

GSCJ-8301B1 SMT Loader and Unloader Rack, PCB Board SMT Material Frame, Circuit Board Rack for Material Handling Cart | GSSMT, PCB Magazine Loader, PCB Magazine Rack, SMT PCB Magazine, PCB Magazine Unloader, PCB Magazine Handling, PCB Magazine Storage, PCB Magazine Transport, PCB Magazine Capacity, PCB Magazine Holder, PCB Magazine System.