811 - 820 of 966
home appliance testing equipment
Selling leads
|
... made after the test of clause 21. A force of 100 N is exerted on the pin, which is supported as shown in IEC60884-1, figure 14, for 1 min in a ...
2024-12-09 10:47:48
|
|
...-1:2009,IEC62262:2002 clause 6 and IEC60068-2-75, it applies to test the mechanical collision strength degree when the electrical equipment shells ...
2024-12-09 11:56:30
|
|
... ACCESS AREAS there is adequate protection against contact with bare parts of TNV - 1 , TNV - 2 and TNV - 3 CIRCUITS except that access is ...
2024-12-09 13:14:44
|
|
... hazardous mechanical parts. It is also used to verify the protection against access with a wire. Test probe D is also used to verify the ...
2024-12-09 13:15:41
|
|
...Test Finger Probe Probe length with 100±0.2 Product information of Test Finger Probe Probe: This testing probe is used for interlocking apparatus ...
2024-12-09 22:42:21
|
|
...Testing Apparatus Product Information: This device is according to the IEC60320-1, figure 19 standard requirement to design. It is used for the ...
2024-12-09 10:47:48
|
|
...(s) without undue damage to the conductor(s). Appliance is apparatus of checking damage. The terminal is placed in the test apparatus according to ...
2024-12-09 10:47:48
|
|
... information: Telecom test probe complies with IEC60950 figure 2C and UL6500 figure B.1 standards. It is used for the bare parts of TNV circuits of ...
2024-12-09 10:47:48
|
|
...testing probe is used to verify the protection against access to hazardous parts through top openings. It meets IEC, EN, UL and CSA Standards, ...
2024-12-09 10:47:48
|
|
...Test Probe The young adult joint arm probe conforms to EN 50636-2-100 figure 1 and IEC 50636-2. It is used to simulate the young adult who are ...
2024-12-09 10:53:46
|