161 - 170 of 463
compression test device
Selling leadsImpact Testing Mechanical Testing Machine Calibration Device For Spring Impact Hammer As Per Annex B
... of the pendulum 30mm Balance weight 2J Copper weight 1 piece Material Stainless steel Description: This device is
2024-12-09 11:49:57
|
...: This device is suitable for drop impact test for equipment enclosure. Test sample: Luminaries, Audio, video and similar electronic apparatus, ...
2024-12-09 12:31:11
|
...Test Ehc Vertical Hammer Electromagnet Release Tester Of 2J 5J 10J 20J 50J Product Introduction This device conforms to the standard requirement of ...
2024-12-09 12:42:42
|
...Device With 90° And 120° Sector-Shaped Profile IEC 60811-3-1 clause 8.1.3 Position of each test piece in the test apparatus The indentation device ...
2024-12-09 17:07:01
|
...Testing Machine Nylon Base 1000*1000mm Thickness 8mm Introduction: This device conforms to the standard requirement of the IEC60068-2-75 Test Ehc. ...
2025-07-11 00:02:39
|
... 4.14.3. The adjustment device, equipped with the appropriate cable or cord shall be operated in accordance with following table. A cycle of ...
2024-12-09 10:47:48
|
...-outlets shall not impose undue strain on these socket-outlets. Compliance is checked by engaging the device, as during intended use, with the ...
2024-12-09 11:01:24
|
... bending performance of wire and cable at low temperature. The equipment is mainly composed of low temperature thermostat, winding device and ...
2024-12-09 22:27:36
|
...Device 11 Rigid Test Finger Probe Products information: This rigid finger probe conforms to the standard requirement of IEC61032 figure 7 device 11...
2024-12-09 10:47:48
|
... with the testing probe for the convenience and correctness. In the two output electrodes, the low potential (the red one) is connected with the ...
2024-12-09 10:55:33
|