24V Digital 2 Heat / 1 Cool Room Heat Pump Thermostat With Dual Powered

24V Digital 2 Heat / 1 Cool Room Heat Pump Thermostat With Dual Powered

Terminal Designations:

Set Program Schedule:

To customize your program schedule, follow these steps:

1. Select HEAT or COOL from the system switch.

Note: You have to program heat and cool each separately.

2. Press MENU

3. Press SET SCHED.

Note: Monday-Friday is displayed and the WAKE icon is shown. You are now programming the wake time period for the weekday setting.

4. Time is flashing. Use the + or - key to make your time selection for the weekday WAKE time period (step: 10 minutes).

5. Press NEXT STEP

6. The setpoint temperature is flashing. Use the + or - key to make your setpoint selection for the weekday wake period (step: 1℉).

7. Press NEXT STEP

8. Repeat steps 4 through 7 for weekday LEAVE, RETURN and SLEEP time period.

9. Repeat steps 4 through 7 for Saturday WAKE, LEAVE,RETURN and SLEEP time period.

10. Repeat steps 4 through 7 for Sunday WAKE, LEAVE,RETURN and SLEEP time period.

11. Press DONE when completed or quit after 15 seconds automatically.

Manual Setting:

Temporary Temperature Manual Setting

1. Use + or - to select the temperature.

2. Confirm automatically after 15 seconds. Running out the current PROG period and then running the manual setting program, press RUN SCHED to exit.

Run Permanent Hold Temperature

1. After setting the above manual setting, then press HOLD and display HOLD.

2. Confirm automatically after 15 seconds.

The thermostat will now permanently stay at this setpoint and can be adjusted using the + or - keys.

Press RUN SCHED to exit either temporary or permanent hold.

Technician Setup Menu:

1. Press MENU button

2. Press and hold TECH SET button for 3 seconds.

3. Configure the installer options as desired using the table below.

Use the + OR - keys to change settings and the NEXT STEP or PREV STEP key to move from one option to another.

FILER Setting: Display FlSE, flashing OFF (the default OFF), select from OFF, 50~2000 hours.

Temperature Calibration: Display CAL and flashing 0℉ (the default value 0), select from -4~4℉.

Compressor Shortest Running Time Setting: Display AN ON and flashing OFF (default setting), select from OFF, 3, 4 or 5 minutes.

Compressor Delay Time Setting: Display CO OF and flashing ON (default setting), select from ON or OFF.

Cooling Swing Setting: Display df CO and flashing 0.5, choose from 0.2~2.0 (factory default setting: 0.5℉).

Heating Swing Setting: Display df HE and flashing 0.4, choose from 0.2~2.0 (factory default setting: 0.4℉).

℉/℃ Selection: Setting F(Fahrenheit) or C(Celsius).

24H/12H Selection: Setting the 24 hours or 12 hours time format.

 ELEC/GAS Selection: Select the ELEC or GAS.