DC48V 200A 10700W Telecom Rectifier System, Input Voltage: 220VAC, Output Voltage: 48VDC
 

Quick Details:

Payment & Shipping Terms:

1. Application

(1) Small scale program controlled exchangers

(2) Access network

(3) Transmission equipment

(4) Mobile communication

(5) Satellite communication ground station

(6) Microwave communication

2. Features

(1) Adoption of active power factor compensation technology with factor >0.98

(2) Wide operating range of AC input voltage: 90～290Vac

(3) Operating temperature range: -25°C～+55°C

(4) Zero current/voltage switching tech with high efficiency ≥91%

(5) Lifecycle of battery prolonged by perfect battery management, including electrical charge/discharge management, battery temperature compensation, battery capacity test, reversal connection proof protection, low voltage protection etc.

(6) Hot-swappable

(7) Input over/under voltage protection

(8) Output over voltage protection

(9) Output over current protection

(10) Output short circuit protection

(11) Auto current sharing, parallel output

(12) Embedded mounting

3. System Configuration

The system consists of power distribution unit, rectifier module (from 1 set, up to 4 sets) and 1 monitoring module. The configuration is optional, as following table:

4. Operating Principle

AC power is first input AC-INPUT MCB and then feed into the rectifier module after lightning proof and filtering. AC-INPUT acts as protection to over load and short circuit to AC power. The user’s battery is connected to the DC output side through MCB BAT and KM2, and the circuit breaker provides disconnection control, over-load and short-circuit protection to the battery.

Under normal conditions, every parameter of rectifier modules and power distribution unit are all under control of the monitoring module, operating according to the pre-set parameter or user’s commands. If AC mains faults, the battery will power to the system. With the battery discharge, the terminal voltage of the battery starts to descend. When battery voltage is under -47V±0.5V, the monitoring module sends DC under voltage alarm signal and when battery voltage is under -46.0V±0.5V (adjustable), the KM1cuts off non-priority loads and retaining power to priority loads. If battery voltage drops to -43.0V±0.5V (adjustable), the KM2 will cut off output of priority loads and then the power system will stop working. If the external AC mains recovers, the system will normally work again. (All above monitoring data are system default values and can be reset by user).

Except for battery over-discharge protection, battery or load over-temperature protection is prohibitive under default, users can send command to activate or inactivate according to the demanding.

5. System Properties

6. Electrical Connection

Chassis connects with external electric through system interface board. As shown in figure below:

Descriptions:

1. Signal transfer board;

2. BAT- ;

3. LVBD ;

4. LVLD ;

5. AC Input ;

6. Anode Copper Bar;

7. Ground Copper Bar;

7. Packing and Shipping



Our Delivery Agent

The goods can be shipped by sea, by air, by courier, by land, by train, etc.
Besides the following delivery agent, we can also look for the delivery agent with the best price in china if you need us to do for you.



8. Our Contact Information

Mobile Phone: 0086-13752765943
Telephone: 0086-0755 66600941

Email: info@estel.com.cn

           lxf.estel@hotmail.com
Skype: fiona.liang10

9. Our Partner