1746-P1 1746P1 AB AB SLC Rack Mounting Power Supply

1746-P1 1746P1 AB AB SLC Rack Mounting Power Supply

⇒ Click here for good price 1746-P1

Contact Us

Email: miya@mvme.cn (CLICK)

QQ: 2851195450

Tel: 86-18020776792(CLICK)

Skype:miyazheng520(CLICK)

Product Details

The AB 1746-P1 is an SLC 500 power supply. It has a line voltage of 85 to 132 Volts or 170 to 265 Volts AC at 47 to 63 Hertz and with a typical line power requirement of 135 VA. Its internal current capacity is 2 A at 5 Volts DC and 0.46 A at 24 Volts DC and its inrush current is a maximum of 20 A. This power supply also has a 24 Volt DC user-power current capacity of 200 mA and a 24 Volt DC user-power voltage range of 18 to 30 Volts DC. The maximum user-supplied overcurrent protection is 15 A and the isolation between the input terminals and the backplane is 1800 Volts AC RMS for 1 second. Measuring 5.5 x 2.3 x 5.7 inches and weighing 2 pounds or 0.9 kilograms, this power supply can be installed in a 1746 chassis. It also has an operating temperature of 0 to 60 degrees Celsius and the current capacity is derated by 5% when the temperature exceeds 55 degrees Celsius.

The input jumper must be set before applying power to the 1746-P1 power supply during installation. This is because the exposed pins have hazardous voltage when power is applied and this may result in injury. This power supply comes with fuse protection but this is limited only to guarding against fire hazards due to short-circuit conditions. For user-power overcurrent conditions, the 1746-P1 Series A that is made in Japan will undergo a power supply shutdown and CPU fault and the recovery procedure is to reload the user program. For the 1746-P1 Series A that is made in Malaysia, the CPU continues but a 24 Volts DC user shutdown occurs and the recovery procedure is to correct the overcurrent condition. When undervoltage happens, the 1746-P1 power supply will continue to operate the SLC 500 controllers for a short time and it will stop supplying power to the controllers when the input voltage drops below the recommended operating range for a time that is longer than the CPU hold-up time. For the 1746-P1 power supply, the CPU hold-up time is 20 ms for the full load and 3000 ms for no load. Operations will resume once the power supply gets the normal input voltage.

Why choose us

1. We will provie you the product info and picuture
2.Large stock, fast delivery
3.Competitive prices and immdiate quotation
4.Professional service,professional technical support
5. Warranty time is one year.
6. Strict test machine before shipment.
7. We could help you to get any components which is difficult to get

More Products