ABB Module DSQC227 YB560103-BK ABB DSQC227 Drive Board reputation based

ABB Module DSQC227 YB560103-BK ABB DSQC227 Drive Board reputation based

Product Description:

The latter option has the advantage that the switch-over can also be controlled remotely, e.g. via telephone line and suitable dial-up modems. The ASCII character DEL has the decimal code of 127 and the hexadecimal code of 7FH. You can generate this character by simultaneously pressing the control key For the passive mode of COM1, the interface parameters can be changed using the SINIT function block. If the changed values are not plausible, the COM1 interface uses the default values.
The interface is newly initialized each time the operating mode is switched over. The active mode parameters are set in the active mode, whereas in the passive mode the parameters established
by the SINIT block or the default values are set.

Related Product Recommendation:

Product's Character:

While a communication between the DRUCK or EMAS blocks and a device connected to COM1 is being executed, it may be come necessary to modify the program, for example. For this purpose, you must switch over COM1 from the passive mode into the active mode. Switch-over: Passive mode ––> Active mode There are three possibilities for switching over: Set the RUN/STOP switch to the "STOP" position
Replace the cable 07 SK 91 by cable 07 SK 90 (if KW 00,06 is set to <0 or >2)Send the following special command to the PLC:

The use of the product: