Servo Control Computer System Laboratory Testing Equipment Tensile
Testing MachineServo Control Computer System Tensile Testing MachineDescription of lab testing equipmentThis machine is controlled by computer and is widely used in the
mechanical property test of rubber, plastic, wire and cable,
textile, waterproof materials, non-woven fabrics and other
non-metallic materials as well as metal wires, metal foils, metal
plates and metal bars. It is also suitable for the tensile,
compression, peeling, shearing, tearing and bending (folding) tests
of various finished products with special clamps. It can print
multiple data, and can make graphic output comparison according to
different data, with high control precision and simple operation;
Modular design is adopted, and various accessories are complete and
flexible. This machine is mainly used for testing the mechanical properties
of metals such as tension, compression, bending, etc. It can also
realize multiple dead cycle tests such as constant stress, constant
strain, creep, relaxation, axial, radial, etc. The tensile
strength, yield strength, elongation, constant elongation stress,
constant stress elongation, elastic modulus and other parameters
can be automatically calculated according to GB, JIS, ASTM, DIN and
other standards. Introduction to control software Software operating system language: Simplified Chinese. Force value unit: N, KN, Kgf, Lbf, length unit: mm, cm, in, freely
convertible Control mode: computer software sets speed, load break (break),
running time and other control modes Special manual operation box: it is convenient for calibration and
positioning when holding the test piece Automatically judge material fracture, crushing, etc. and
automatically stop the machine. Automatic return can be set
Stress strain, strain time,
stress time.
The vertical and horizontal
coordinates of the curve can be set arbitrarily. Available test data: maximum strength, minimum strength, breaking
value, upper and lower yield strength, tensile strength,
compressive strength, elastic modulus, elongation, maximum, minimum
and average values of stripping interval, etc. (To be selected by
the customer before ordering) It has multiple protections such as
overload, overcurrent, overvoltage, undervoltage, overspeed,
travel, etc. The data results are exported from the crystal report
format currently adopted by the national standard.
Specifications:Capacity Selection(kg) | 100,200,500,1000,2000 | Precision | Level 0.5, the accuracy of test force indication is better than ±
0.5% | Load Sensing | High precision tension pressure transducer | high resolution | 1/100000 | Magnification | 24 bit AD stepless amplification | Unit selection | N, KN | Test speed range | 0.5~500 mm/min | Speed control accuracy | ± 0.2% (Grade 0.5) | Test effective width | 400mm | Test stroke (including fixture) | 800mm | Overload setting protection function | When exceeding 10% of the set test force, the system automatically
stops for protection | Travel setting protection function | Setting protection of upper and lower limit of travel, | Power | AC servo motor&servo drive controller | Power consumption | 0.5 kVA | Power supply | 1ø, 220 VAC, 50/60 Hz | Hardware Specification | The computer hardware specifications provided shall be purchased
from the original ACER brand, or provided by the customer | Special software | Refer to the software version of the computer measurement system | Standard accessories | One set of tension clamps, one set of tools, one manual and one
warranty | Punctuation extensometer | Large deformation (gauge length: 25,50,75,100mm) | Fixture | Refer to fixture catalog for purchase, or provide sample
specifications for design and manufacturing |
|