Rectangle Decorative Anodized Aluminum Profiles Corrosion Resistance

Anodic Oxidation Coated Aluminum , Weatherability , Corrosion Resistance , Decorative

1.Introduction of our factory

1.Process flow

1) The oxidation of silver white material and silver white electrophoresis material

Shelf - washing - water washing - low temperature polishing - water washing - water washing - Pliers - oxidation - water washing - water washing - water washing - sealing - water washing - water washing - lower shelf - air drying - inspection into the electrophoresis process - packaging

2) Oxidation of abrasive and abrasive particles

On the shelf - oil - Wash - acid erosion - Wash - water wash - alkali erosion - Wash - water wash - water wash - water wash - forceps - oxidation - Wash - water wash - water wash - water wash - bottom shelf - wind drying - Inspection - packaging into electricity Swimming process

3)Oxidation of coloring materials and coloring electrophoretic materials

Shelf - washing - low temperature polishing - water washing - water washing - forceps - oxidation - water washing - washing - water washing - coloring - water washing - water washing - water washing - water washing inspection into electrophoresis process-The next shelf - air drying - Inspection - packaging

3.Feeding

(1) The contact surface of the hanger should be grinded clean before the material is on the material, and the formula is calculated according to the standard number. The calculation formula: the number of the material = standard current standard current density and the area of the single section section.

(2)The principle of considering the number of supports on the shelf.

(3) Calculation of oxidation time: oxidation time (T) = film thickness K. Current density K is the electrolytic constant. Take 0.26 - 0.32, t unit is minute.

(4) The upper row must be placed on the basis of the number of sections specified in the section area and the upper row number table.

(5)In order to facilitate drainage and exhaust, the upper row should be tilted and the inclination should be 5 degrees.

(6)The two ends can exceed 10 to 20mm of the conductive rod, not more than 50mm at most.

Please tell us the information below, and we will give the best suggestion to you!

1. Where you intend to use the aluminium profiles?
2. If you have the estrusion drawing, send us and we develop the correspondence mold.
3. Which color you want or tell us the architectural style you like.
4. Purchase quantity. It will convenient us to give you the best price.
       

            Welcome to visit our company !

                Choose us & contact us!