Non Combustible Coated Ceramic Subminiature Wire Wound Resistor

Non-Combustible Coated Wire Wound Resistor Power Supply​
 

OC_212-datasheet.pdf

REQUIRENTS IN USE

1,IN THE HIGH HUMIDITY SITUATION, IT WILL MAKE THE SOLDER ABILITY WORST. PLEASE PRESERVE THE RESISTORS IN 40°C ,70 RH BELOW

2,PLEASE DON`T OPEN THE MINE PACKAGE WHEN YOU PRESERVE IT

3,WHEN IN THE HIGH TEMPERATURE SITUATION, PLEASE ACCORD TO THE PICTURE OF “POWER DERATING CURVE” REDUCE THE USE OF POWER RATING

4,YOU SHOULD AVOID THE CONNECTOR OF RESISATNCE REPLACED BY LATGE VOLTAGE AND POWER

5,AS THE PAINT IS NOT SUBJECT TO EXTERNAL SHOCKS INCOMBUSTIBILITY LESS,
IT SHOULD BE DISPOSED OF IN A VARIETY OF REDUCING THE BODY'S RESISTANCE COLLISION

Mechanical Performance

The terminal shall withstand 4 bends of 90°rotation without any breakage or damage, when the Resistor is fixed in vertical position.

Fixing the resistor body, a static load of 2.5Kg is to be gradually applied into the terminal for 10seconds without causing any looseness and fall.

To bend the lead wire at the point of about 6mm from resistor body to 90°,then catch the wire at 1.2±0.4mm apart from the bend point end and turn it (clockwise) by 360 degrees Perpendicular to the resistor axis at speed of sane 5 seconds per turn, and do the same Counterclockwise again which constitute a whole turn. Repeat the turn for 2 times without Causing any break and looseness.