IC9445B200AB GE FANUC Limit Switch Lever Watertight Standard
Contact 2 Circuits
Product Description
Limit Switch, Lever, Watertight, Standard Contact, 2 Circuits
Limit Switch, Lever, Watertight, Standard Contact, 2 Circuits,
IC9445 Lever Limit Switch
Technical Specifications
| Nominal Rated Voltage: | 120/240 VAC or 125 VDC |
| Input Voltage Range: | 85 to 264 VAC or 100 to 300 VDC |
| Input Power: | 90 VA with VAC or 50 W with VDC |
| Load Capacity: | 30 Watts |
| Location on Baseplates: | Left most Slot |
| Communication: | RS 485 Serial Port
|
▪ Selectable resistance measurements in tenths of ohms, tenths of
degrees Fahrenheit, or tenths of degrees Celsius ▪ Individual
channel configuration ▪ Selectable resistance ranges: 0 – 500 ohms
and 0 – 3000 ohms ▪ Selectable RTD input as resistance or
temperature (Celsius or Fahrenheit) ▪ Reports high/low,
under-range/over-range, open wire and input short alarms. ▪ Two
data acquisition rates based on 50 Hz and 60 Hz line frequencies ▪
Configurable channel activation The module automatically performs
A/D calibration at powerup. Automatic calibration is then repeated
periodically to compensate for changes in the ambient temperature.
LED Indicator
The OK LED indicates module status: ▪ On green indicates normal
operation ▪ Flashing green indicates boot mode or update ▪ Flashing
amber indicates self-diagnostic error ▪ Off indicates no 3.3V
backplane power.
Using the Module in Hazardous Locations
▪ WARNING - EXPLOSION HAZARD - SUBSTITUTION OF COMPONENTS MAY
IMPAIR SUITABILITY FOR CLASS I, DIVISION 2;
▪ WARNING - EXPLOSION HAZARD - WHEN IN HAZARDOUS LOCATIONS, TURN
OFF POWER BEFORE REPLACING OR WIRING MODULES.
▪ WARNING - EXPLOSION HAZARD - DO NOT DISCONNECT EQUIPMENT UNLESS
POWER HAS BEEN SWITCHED OFF OR THE AREA IS KNOWN TO BE
NONHAZARDOUS.
▪ Equipment labeled with reference to Class I, Div. 2, Groups A, B,
C and D, Hazardous Locations is suitable for use in Class I, Div.
2, Groups A, B, C, D or non-hazardous locations only.
▪ Equipment labeled with reference to Class I, Zone 2, Groups A, B,
C and D, hazardous locations is suitable for use in Class I, Zone
2, Groups A, B, C, D or non-hazardous locations only.
▪ Be sure to read the installation instructions provided with the
module and its terminal assembly. These instructions specify the
use of copper conductors and wire gauge and type requirements.
Company profile:
Shipping:
