YASKAWA SERVOPACK SIGMA III 50/60hz SGDS Series Servo Amplifier 3PH SGDS-10A01A

YASKAWA SERVOPACK SIGMA III 50/60hz SGDS Series Servo Amplifier 3PH SGDS-10A01A

Several ZPL II instructions use these object names. Object names have no default and must be supplied. Extensions have the defaults defined below. Depending on the ZPL II instruction, if an extension is missing, incomplete or incorrect, a default will be used. Defined extensions for ZPL II Object names, along with their related ZPL II instructions are: n .ZPL ZPL II label format (^DF or ^XF) n .FNT fonts in Zebra format (~DB, ~DS, or ^XA) n .GRF Zebra bitmap format (~DG, ^IS, ^IL, ^XG or ^IM) Depending on the ZPL II instruction, the Object name and Extension may support the use of the asterisk (*) and question mark (?) as wild cards

In most cases, the printer can be configured from either the front panel or through various ZPL II instructions. Once a configuration instruction is received by the printer, the change will usually affect the current label format and any future label formats until changed, the printer is reset, or the printer power is turned off. The next label printed will reflect the new instruction.

This section discusses how to use the ZPL II printer configuration instructions. The following is a list of these instructions. n ^MM (Print Mode) - Sets the printer to one of its four basic printing modes; Tear-Off, Rewind, Peel-Off and Cutter. n ^MN (Media Tracking) - Sets the printer for either Non-Continuous or Continuous media. n ^MT (Media Type) - Sets the printer for either Direct Thermal media or Thermal Transfer media. n ^MD (Media Darkness) - Adjust how dark the printing will be by adjusting the “burn temperature” of the printhead. n ^LT (Label Top) - Shifts printing up to 64 (or ±120 dot rows based on firmware version) dot rows up or down from the current Label Home position. n ^SS (Set Media Sensors) - Allows the user to override all of the internal values established after running a media profile. n ^MP (Disable Mode Protection) - Used to disable the front panel Darkness, Position and Calibrate modes. n ^JZ (Reprint After Error) - Reprints a label if it was partially or incorrectly printed due to an error condition.

SPECIFITIONS