New Made in Japan Industrial Yaskawa Servo Drive Output 3 Phase SJDE-02APA

New Made in Japan Industrial Yaskawa Servo Drive Output 3 Phase SJDE-02APA

DESCRIPTION

• Industrial Servo Drive
• ServoPack 
• Servo Controller

SEPCIFICATIONS

Input Main Voltage: 200-230V
Input CONT Voltage: 200-230V
Input Mian PH: 1
Input Mian Frequency:50/60HZ
Input Mian Current : 8.9A
Input CONT Current : 0.25A
Output Power :750W
Output Voltage: 0-230V
Output Current: 3.7A
Output Frequency:0-300Hz
Output PH :3
Temperture: 0-55℃
Place of Origin:Japan
Efficiency:IE 1

SIMILAR PRODUCTS

SJDE-01APA

SJDE-02APA

SJDE-04APA

SJDE-04APA+SJME-04AMB41

SJDE-08APA

SJME-01AMA41

SJME-04AMA41

SJME-04AWA41

SJME-08AWA41

Manual Alignment

• Connect the servo to the OctoIII

• Connect the Remote Alignment board with the flat cable.

• Put the Run/Align jumper on the OctoIII to the Run position.

• Put on the Center jumper

• Mount the servo such that the points are midway between the stock rails

• Remove the Center jumper

• Put on the Mtry jumper

• On the Remote Alignment board:

• Use Next to set the the same number as the servo on the remote.

• Set the servo to Close or Thrown with Cls/Thr as desired (if the servo does not move check that the Mtry jumper is on). Thrown is indicated by a slow flashing of the LEDs.

• Press Cls/Thr for ~ 1 sec. The LEDs will start flashing rapidly.

• Press <--- and ---> repeatedly until the correct position is achieved.

•Pressing <--- and ---> at the same time will recenter the servo. • Press Next briefly to save the position.

• Repeat for the second position of the servo after changing the servo position with Cls/Thr.

Speed - With the servo you want to adjust selected Hold the Speed (right) button. Press <- or -> to raise/lower the speed. The servo will move to show the new speed after each press. The left button saves the new speed. Servo On/OFF - By default, the servos stay on all the time. Sometimes you might wish to have the servo turn off between movements to prevent it from drawing power. To do this use the remote aligner. With the servo to be changed selected, hold the Speed (right) button and press the Next button briefly). The LED will flash twice quickly to indicate the turnout will turn off between movments. (Note the LED will blink on/off slowly to indicate the servo is in the thrown position - the lock is 2 brief flashed followed by a long pause and quite distinct).

OTHER SUPERIOR PRODUCTS