Yaskawa Sgma 3 Series 3 Phase Servo Motor Driver Mechatrolink SGDS-08A12AY562
|
|
Industrial Servo MotorYASKAWA SGDS-08A12AY562 SERVO DRIVER 750W Mechatrolink
Quick Details Brand Name:Yaskawa Model Number:SGDS-08A12AY562 Input Voltage: 200-230V Input Current: 8.8A Input Frequency:50/60HZ Input PH : 1 Output Power : 750W Output Voltage: 0-230V Output Current: 5.5A Output Frequency:0-300Hz Output PH :3 Temperture: 0-55 Place of Origin:Japan Efficiency:IE 1
OTHER SUPERIOR PRODUCTS Yasakawa Motor, Driver SG- Mitsubishi Motor HC-,HA- Westinghouse Modules 1C-,5X- Emerson VE-,KJ- Honeywell TC-,TK- Fanuc motor A0- Rosemount transmitter 3051- Yokogawa transmitter EJA- Contact person: Anna E-mail: wisdomlongkeji@163.com Cellphone: +0086-13534205279
Similar Products SGMAH-02BAA21 SGMAH-A6AAA4C SGMAH-A3AAA41 SGMAH-01AAA21 Connecting to Peripheral Devices This section shows a standard example of connecting Σ-Series products to peripheral devicesand briefly explains how to connect to each peripheral device. NOTE Read the following notes before wiring: • Connect only one cable to one terminal. Never connect two cables to one terminal. • Do not solder the cable. • Peel back the cable shield by about 10mm (0.39in.) min. Then insert the cable into the terminal securely and tighten the screw. Never leave the bare wires outside of the termianl. • When the cable is inserted into the flat terminal, use the following ferrules. Non−insulated ferrules, 2.5mm2 or less (Made by PHOENIX CONTACT) <Reference> Terminal block type: FRONT 2.5H/SA5 Form a power ON sequence as follows: a) Form a power ON sequence so that the main power is turned OFF when a servo alarm signal is output. (See the circuit diagram shown on the previous page.) b) Hold down the power ON push-button for at least two seconds. The Servopack outputs a servo alarm signal for approximately two seconds or less when the power is turned ON. This operation is required to initialize the Servopack. NOTE After turning the power OFF, do not touch the power terminals for 5
minutes. High voltage may remain in the Servopack. Avoid frequently turning the power ON and OFF. Since the Servopack has a capacitor in the power supply, a high charging current flows (for 0.2 second) when the power is turned ON. Therefore, frequently turning the power ON and OFF causes the main power devices (such as capacitors and fuses) to deteriorate, resulting in unexpected problems. |
| Product Tags: electric servo drive ac servo pack |
|
MR-S12-80A-Z33 MITSUBISHI Servo Drive AMP AC 2 Axis Option Card RF 322 |
|
ACH550-01-031A-4 ABB AC Hvac Drive 550 Series IEC Installation Setup 380-480 VAC |
|
3G3JX-A4004 OMRON JX Frequency Inverters AC Drive 1/2HP 480V 0.4KW 3PH |
|
EMERSON SM-ETHERNET ETHERNET MODULE RJ45 CONNECTIVITY Drive Interface |
|
ABB Inverter Standard AC Drive ACS-550-01-059A-4 380-400V 30kw 59A Low Voltage Drives |
|
A20B-0007-0040/04A PC BOARD DI/DO BOARD I/O RELAY CARD 6T/M CONTROL CNC |