Zinc Plating Upholstery Replacement Springs HS Code 73202090 For Furniture

Zinc Plating Silver 3.0mm - 4.0mm Precut Sofa Seat Springs , Zig Zag Springs For Furniture

 Product Descriptions

Serpentine Springs, or zig-zag springs are almost exclusively used in the manufacture or refurbishment of furniture seating. The springs are used not only in the seating element, but also in the arms and on the backs of the upholstered furniture.

Serpentine Upholstery Springs are manufactured in a continuous ‘S’ shape and sold either in specific cut lengths or a continuous length, where the user will cut the spring to a specific length dependent upon the application. The wire size used is normally standard 9 gauge spring steel wire (which equates to 0.148” or 3.76mm) for the seating application and 11 gauge (which equates to 0.120” or 3.05mm) for the backs and or arms.

Advantage Of Product

1. it's made of high carbon stell wire,has good elasticity and keep shape for more than 8 years.

2. Can be made with different wire diameter to fit for the different usage demands.

3. Passed the fatigue test,can reach exceed 20,000 times not out of shape.

4. Antirust treatment,surface of the spring was processed with the enviromental paint.

5. Mostly be used in sofa seat and back.

Measuring

When measuring the required length, it is important to only measure the distance across the area to be bridged with the Serpentine Spring, and not allow for any bowing of the spring which may or may not be required. This measurement will make the difference between the spring fitting perfectly, or sagging or lifting of the cushion. So it needs to be right.Another factor when using serpentine upholstery springs is the distance between the springs themselves across the chair (or couch). If the gap is too wide, then the cushion will have a tendency to fall down the oversized gap. Conversely, if the gap is too small it may end up either being too strong with little or no ‘spring action’ in it, or simply be too hard to comfortably sit on. Usually a couple of inches gap, (or 50mm) is perfectly adequate. When measuring, please do not allow for the arc, the inside frame measurement is the size required.

Product Details

Application

It's normally used for sofa seat / Couch / Chair,can be cutted in pieces.

Product Photo