NM6-135 Diesel Engines for Fire Pump Drivers
|
|
NM6-135 Diesel Engines for Fire Pump Drivers
Pump Data Sheets:
Characteristics
It is a kind of engine in accordance with fire fighting standard. Compared with normal engine, it is more stable and reliable. Its design concept is to protect the security of human and their property, but normal engine considers more about its performance.
1. starting system: there are three kinds of starting types of fire fighting engine: main controller starting, instrumentation starting and emergency starting. And from the crank speed within 20s, to the rated speed and rated power.
Main controller starting: controller can result in the pressure of pipe net goes down then automatically starting , and press 'manual' buttom to start. Instrumentation starting: Press 'manual’ buttom of the instrumention to start. Emergency starting: if the main controller and instrumention all broken down , emergency manual starting can start the fire engine.
2. Battery: fire fighting engine usually equiped with two sets of batteries for power supply. To ensure the battery full of power and can quick start the fire fighting engine at any time, here are two kinds of charging ways: connecting to AC power or using generator of the engine for charging.
Battery capacity: At 40℉ (4℃), each battery shall have twice the capacity sufficient to maintain 3-minute attempt-to-start cycle, which is six consecutive cycles of 15 seconds of cranking and 15 seconds of rest. Batteries based on calculations, to have capacity for 72 hours of standby power without ac power being available for battery charging.
3. Jacket water heater: fire fighting engine equipped with jacket water heater to heat the coolant and keep 49℃ of the cylinder,to ensure the engine can quick start at any time. 4. Cooling system: fire fighting engine equipped with water pump , as the pump end is full of water and water cooling has good effect, cooling type of diesel engine normally choose water cooling.
5. Exhaust system: fire fighting engine need equipped with seperate exhaust system ,and connect flexible joint on the exhaust vent, to absorb the heat and cut off the engine vibration .
6. Fuel supply &return system: fire fighting engine must equipped with an independent fuel supply &return system, The fuel tank is sized for 5.07 liter/kW (1gal/HP) plus 10% (5% for expansion and 5% forsump),for make sure enough fuel.
7. Coupling:Engines shall be connected to horizontal shaft pumps by means of a flexible coupling.The flexible coupling shall be directly attached to the engine flywheel adapter.
8. Alarm signal: when fire fighting diesel engine at low oil pressure,high coolant temperature, low coolant temperature, over speed, high cooling raw water , they will send out alarm signal, but all this alarm signal will not fire fighting diesel engine , except over speed .
|
| Product Tags: fire pump engine fire diesel engine |
|
NM6-135 Diesel Engines for Fire Pump Drivers |
|
High Efficiency Fire Pump Diesel Engine 300KW With Compact Structure |
|
UL Listed NM4-105 Diesel Fire Pump Driver NMFIRE |
|
Powerful Durable Diesel Engine Fire Pump Driver and Fuel Tank Capacity 50-550 Gallons 1250GPM |
|
Fire Pump Set Diesel Engine Fire Pump Driver with 130-1005 Gallons Fuel Tank Capacity and 1500 GPM Flow Rate |
|
Water Cooled Diesel Engine Fire Pump Driver for Fire Pump Set Speed 1500-3000 RPM Water-Cooled Diesel Engine 1000GPM |
