If special need, also could be customized:

Item: Solar Panel Exclusion Clips

J Hook Material: Stainless Steel

J Hook Diameter: 2.0mm

J Hook Length: 100mm

Self-lock Washer Material: Stainless Steel

Self-lock Washer Diameter: 38mm

Self-lock Washer Thickness: 0.4mm

Self-lock Washer Surface: Double Side UV Resistant Black Coating

Item: Solar Panel Exclusion Clips

J Hook Material: Aluminum

J Hook Diameter: 2.5mm

J Hook Length: 115mm

Self-lock Washer Material: Aluminum

Self-lock Washer Diameter: 38mm

Self-lock Washer Thickness: 0.6mm

Self-lock Washer Surface: One Side UV Resistant Black Coating

1. Put the clip end of the fastener onto the panel edge underneath the panel. Use a clip every 18" or less. Slide as far outward as possible so the clip is seated against the lip of the panel.
2. Set the wire mesh screen in place. Make sure the fastener rod comes through the screen at an upward angle to keep pressure of the screen on the rooftop.
3. Slide the speed washer onto the shaft of the clip assembly until snug. Make adjustments to the screen as needed. Tighten the speed washer to the panel edge.
4. Cut off any excess mesh screen sticking over the top edge of the solar panel array. Cut off the clip assembly rod flush with the exterior of the speed washer.
5. Where the corners come together use two pieces of mesh screen. DO NOT try to bend the screen to go around the corner. Attach the corners together using thin bailing wire or UV rated zip ties.