Galvanized Self Adhesive Insulation Pins Use for Air Conditioner

Quick details of Galvanized Self Adhesive Insulation Pins

Name:self adhesive insulation pins,self stick pins,self stick insulation pins

 
Self Adhesive Insulation Pins​ CAUTION:
 
The user is responsible for determining the suitability of the application. Hangers must be applied

to a clean, dry, non-porous surface that is free of all oil, films, dust, rust, etc. Self-adhering hangers

are not recommended for concrete or painted surfaces. It is important that they not be used where

operating temperatures can exceed 150° F at the point of adhesion. Hangers should not be used on

ceilings or roofs of metal buildings or any surface

the reverse side of which may be exposed to heat concentration from sunlight, etc., direct or otherwise.

Load per anchor should not exceed 3 lbs.

 
Self Adhesive Insulation Pins​ APPLICATION:
 
Best results are obtained when ambient temperature is above 40° F at the time of application. Remove

the release paper from the base plate and apply hanger to a suitable flat surface. A firm straight, forward

pressure should be used. Do not twist. Due to the quick-tack nature of the adhesive, it is very important

that the release paper not be

removed until ready to apply the hanger. Insulation may be applied immediately after properly securing

the hanger. Hangers should be stored at 75° F and 50% relative humidity. It is important that stock be

rotated. Shelf life is estimated at 2 years if stored as recommended.
 


 
WIPE SURFACE CLEAN.Anchor should be applied to a clean, dry non-porous surface
PEEL OFF RELEASE BACKING.NOTE: Double faced foam tape has a one-year active shelf life
STICK ANCHOR IN PLACE.Select location before contact with surface.Press firmly

APPLY FIRM PRESSURE.20 pounds of pressure should be applied all around the base of the anchor
ALLOW TO STAND 15-20 MINUTES.This will permit better adhesion to take place
 
 
Package of Self Adhesive Insulation Pins​ :